11 of 36
ISSUED: 07-24-12 SHEET #: 180-9025-1
2. INFO*
- Displays the following information on the screen for:
•
Transmitter ** - WiFi Channel, Firmware Version, Audio/Video Input, and
Source Resolution.
•
Receiver - Connection, Firmware Version, Video Output, Display Resolution,
WiFi Reception Strength 1/5 to 5/5 (where 1/5 is the weakest signal and 5/5 is
the strongest signal).
*
Displayed information will disappear automatically after 10 seconds.
**
The Transmitter unit’s information will only be displayed if the connection between
the Transmitter unit and Receiver has been established.
3. VIDEO OUT (Receiver) -
Selects the AUDIO/VIDEO output port of the Receiver.
• HDMI
- Selects HDMI as the AUDIO/VIDEO output.
• Component
- Selects Component as the AUDIO/VIDEO output.
• AV
- Selects AV as the AUDIO/VIDEO output.
.
Note:
Remote must be pointing at the Receiver directly to control its output settings.
This may also be accomplished without the use of the remote control by toggling
between outputs via the Power/Source Selection button.
4. LAN* (Red)
- Selects LAN (wired) mode.
5. WiFi CH1** (Green)
- Selects WiFi (Wireless) mode, Ch1.
6. WiFi CH2** (Yellow)
- Selects WiFi (Wireless) mode, Ch2.
*
Your new Receiver is set to WiFi mode. To change to LAN mode, press and hold the
LAN button for approximately 6 seconds or until the Link Indicator Light starts blinking.
**
Your new Receiver is preset to WiFi Ch1. The channel setting on the new Receiver
MUST match the channel setting in your current system con
fi
guration. Make sure
that the connection between the new Receiver and the Transmitter is not established.
(noted by a
fl
ashing Link Indicator Light). To change WiFi channel, press and hold the
desired WiFi channel button for approximately 6 seconds or until the Link Indicator
Light starts blinking.
Notes:
•
When you are pairing your new Receiver with your current HD Flow Pro
Wireless Multimedia Kit the new Receiver MUST be on the same channel as
your current kit.
•
Only the unit that receives the IR signal will change WiFi frequencies. For
proper operation both Receiver and Transmitter units need to be on the same
WiFi channel.
