Peco BRUSH BLAZER TBB-3002, Руководство оператора

Страница: 21 / 42

21
Battery Replacement:
1. Remove the deck and engine hood.
2 Disconnect the negative (-) battery cable.
3. Disconnect the positive (+) battery cable.
4. Remove the battery hold down clamp.
5. Remove the battery.
6. Clean the terminals and cable ends.
7. Install the new battery and replace battery hold down clamp.
8. Connect the positive (+) battery cable.
9. Connect the negative (-) battery cable.
10. Replace the deck and engine hood.
Electrical System Service:
1. Make sure the battery cables and terminals are clean and fastened tightly.
2. Check the electrolyte level in the battery often.
3. Remove any build-up or corrosion on the battery with a baking soda and water solution.
4. Cover the battery terminals with grease to prevent corrosion.
5. Check all electrical wires for loose connections.
Air Filter Replacement:
1. Remove the deck and engine hood.
2. Remove the Donaldson air filter cover.
3. Remove the air filter from the housing.
4. Replace the air filter.
5. Replace the Donaldson air filter cover.
6. Replace the deck and engine hood.
End Of Season Storage:
Ÿ
Change the oil and oil filter.
Ÿ Clean and replace the pre-cleaner filter.
Ÿ Clean any dirt and debris from the muffler area of the engine.
Ÿ
If storing longer than 30 days, use a gas stabilizer.
Ÿ
Close the fuel shut-off valve.
Ÿ Remove any grass, weeds or brush from the blade and deck area.
Ÿ Store the battery in a dry area that will not freeze.
Ÿ
Remove, sharpen or replace blades as necessary.
Engine Service:
1. Refer to the Kohler or Briggs & Stratton service manual for instructions.
Grease:
Grease all fittings (Blade Shaft, Counter Shaft) every 20 hours of operation.
Lubricate with the following greases or their equivalent:
Shell Alvania EP Grease No. 2 - Gulf Gulfcrown Grease No. 2 -
Texaco Molytex Grease No. 2 - American Amolith Grease No. 2 -
Mobil Mobilux EP2
REGULAR MAINTENANCE