Peco BRUSH BLAZER TBB-3002, Руководство оператора

Страница: 10 / 42

10
OPERATION
Blade Engagement/Disengagement
Engagement
While holding the Left Steering Control Handle
with your right hand, reach down and pull up
slowly on the Blade Engagement Control with
your left hand.
Disengagement
While holding the Left Steering Control Handle
with your right hand, push the Blade Engagement
Control down with your left hand.
Tips On Brush Cutting
Obstacles: Always check your work area before mowing and remove any debris that might get tangled in or damage
the machine. If the mower becomes tangled, turn off the engine and disconnect the spark plug wire before reaching
into the mower deck area.
Slopes: Do not operate the Brush Blazer on slopes more than 20 degrees. If you have to operate the machine on
sloping terrain, move across the face of the slope, not up and down.
If The Machine Gets Hung Up: Disengage the blade immediately. Try moving in reverse and backing away from the
obstacle.
Cutting Brush And Saplings: The Brush Blazer can cut saplings up to 4” in diameter. When cutting saplings or
brush, allow the Brush Blazer to ride up and over the material slowly. Adjust your forward speed to varying
conditions. After cutting brush or saplings, you may want to mow over it again to remove any remaining branches. It
its recommended to mow from the trunk end toward the top as the brush lies on the ground.
Cutting In Wet Conditions: Use extreme caution when cutting in wet or slippery conditions. Avoid steep slopes or
other slippery areas. Use a lower speed when conditions are wet or slippery.
WARNING
!
THE BRUSH BLAZER CAN EASILY THROW STONES, STICKS AND OTHER DEBRIS AT
GREAT VELOCITY, POSSIBLY CAUSING PROPERTY DAMAGE OR PERSONAL INJURY.
DO NOT RUN THE BRUSH BLAZER OVER GRAVEL DRIVEWAYS, LOOSE STONES OR
MULCH WITH THE BLADES ENGAGED. IF NECESSARY TO CLEAR DEBRIS FROM MOWER
DECK, DISENGAGE THE BLADE, TURN THE KEY SWITCH TO THE OFF POSITION
AND DISCONNECT THE SPARK PLUG WIRE.