Peco BRUSH BLAZER TBB-3002, Руководство оператора

Страница: 18 / 42

18
TRACK REMOVAL/REPLACEMENT
Removal:
1. Remove the tension from the Front Axle by turning the Tension Bolts counter-clockwise located
on each side of the Brush Blazer (Figure A).
2. With the Tension Bolts fully loosened, you can then push the Complete Front Axle towards the
rear of the Brush Blazer to gain enough slack in the track to remove it from the machine.
3. Remove one or both Tracks from the machine.
Replacement:
1. Remove the tension from the Front Axle by turning the Tension Bolts counter-clockwise located
on each side of the Brush Blazer (Figure A).
2. With the Tension Bolts fully loosened, you can then push the Complete Front Axle towards the
rear of the Brush Blazer.
3. Place the Track onto the Rear Sprocket first and align the Sprocket teeth to the center of the
Track allowing a greater length of slack to be in the Track.
4. Place the loose end of the Track around the Front Axle Wheel.
5. Repeat Steps 3 & 4 if installing both Tracks.
5. With a torque wrench, tension each Tension Bolt (clockwise) to a minimum of 70 foot pounds of
torque.
Note: The tread of the Track is not uni-directional. The point of the ‘V’ in the tread should point
away from the direction that requires more traction.
Front Axle
Tension Bolt - Tension
With Torque Wrench
To 70 Foot Pounds
Track
Sprocket
Teeth
Sprocket
Front Axle Wheel
Move Front Axle
To The Rear To
Remove/Replace
Tracks
Figure A