2) LAN mode
In LAN mode both the mixer and the remote controller should be connected to an external router as shown
below.
In this mode, both Static and Dynamic IP addressing can be used since the mixer’s ethernet controller has DHCP
client capability. Up to 10 remote controllers can connect the mixer at the same time.
Connection Parameters (DR16):
- IP Addressing: Dynamic (DHCP Client)
- IP Address: 192.168.0.100
- Net Mask: 255.255.255.0
- Gateway: 192.168.0.1
*Note: IP Address, Net Mask and Gateway are automatically assigned by the DHCP server (i.e. the router). The
default parameters above will be used only if the DHCP fails to assign the IP address.
Connection Parameters (Remote Controller):
- IP Addressing: Dynamic (DHCP Client)
Note: IP Address, Net Mask and Gateway are automatically assigned by the DHCP server (i.e. the router)
Appendix 2
Ethernet Connection
The DR16 integrates a 100Mbit/s Ethernet port allowing a full real-time remote control and monitor of
the mixer processing functions.
A remote controller (e.g. a laptop) can connect the DR12 in two different modes:
1) Point-To-Point mode
In Point-to-Point mode the remote controller directly connects the mixer through a standard ethernet
cable, without any external router as shown below.
In this mode Static IP addressing should be used since the DR12 Ethernet controller has no DHCP
server capability.
Connection Parameters (DR16):
- IP Addressing: Static
- IP Address: 192.168.0.100 (Default)
- Net Mask: 255.255.255.0 (Default)
- Gateway: 192.168.0.1 (Default)
Connection Parameters (Remote Controller):
- IP Addressing: Static
- IP Address: 192.168.0.xxx , where xxx is in the range [1,254] (and not equals to 100)
- Net Mask: 255.255.255.0
- Gateway: 192.168.0.1
2) LAN mode
In LAN mode both the DR16 and the remote controller should be connected to an external router as
shown below.
In this mode both Static and Dynamic IP addressing can be used since the DR16 ethernet controller has
DHCP client capability. Up to 10 remote controllers can connect the DR16 at the same time.
Connection Parameters (DR16):
- IP Addressing: Dynamic (DHCP Client)
- IP Address: 192.168.0.100
- Net Mask: 255.255.255.0
- Gateway: 192.168.0.1
Note: IP Address, Net Mask and Gateway are automatically assigned by gthe DHCP server (i.e. the
router). The default parameters above will be used only if the DHCP fails to assign the IP address.
