After selecting the MAIN button, The Edit Process section is updated to display the following:
As the Main Left/Right parameters are always linked, the interface only displays one channel. In the main sec-
tion, the user can edit the following parameters:
–POLARITY: Normal/Invert: When the button is ON (Orange color) the polarity of the Main output
signals are inverted.
–DELAY: 0ms - 150ms step 0.05ms
–CMP: RMS Compressor, to use this function the user must first enable the compressor (set to ON, or
ange color) the parameters of the compressor are Threshold (from -30dBfs to 0dBfs - step 0.2dB), RATIO
(from In 1:Out 1 to In 32:Out 1), Knee (from 0% Hard Knee to 100% Soft Knee), RELEASE-TIME (from
1ms to 1sec, step not linear), Attack (from 1ms to 1sec, step notlinear).
–HP/LP Filter: Bypass, 1st, 2nd, 3th, 4th order Butterworth/Linkwitz filter; frequency from 20Hz to
20kHz step1Hz
–FEEDBACK ELIMINATOR: This feedback elim is only for the mains. The Feedback Eliminator is active
only if the relative button is set to ON. The user can also set the Frequency Displacement (range from 2Hz to
8Hz)
–DYN FILTER: the dynamic filter is a loudness EQ where the low and high frequencies will be increased
more or less independantly from the level of the signal. The user can adjust how much to boost the low and high
frequencies (the amount is from 0% (no boost) to 100% max boost). The Filter is active only when turned ON
(when enabled, button is colored orange, ON)
–8 EQ Filter: the parametric EQ filters are active only when the EQ Enable is ON (button colored or-
ange). Each filter can also be enabled or disabled using the ON/OFF button. Each filter type can be set to Peak
(BELL) or “Hi-Shelving” or “Lo-Shelving”, the frequency range can be set to 20Hz-20kHz step 1Hz. The filter
gain can be adjusted on a range of +/-12dB and the Q factor of the filter ranges from 0.3 to 20.
Each filter is shown on the graph and when the filter is enabled the user can modify the frequency and Gain
MAIN Section
