Cyclone for STMicro - User Manual
19
CYCLONE FOR STMICRO
All of the jumpers except Jumper 5 should be left open for this mode, as
shown in
.
Figure 3-17: Jumper Settings for Target Power Connection via Power In and
Power Out Jacks Of Cyclone for STMicro
Only Jumper 5 is installed.
3.15.2
Using Cyclone for STMicro Board Power and Power Out Jack
The target power supply is not needed. The Power Out Jack of the Cyclone
for STMicro will act as a center positive power supply to the target system.
shows the connections.
Figure 3-18: Via Cyclone for STMicro Board Power and Power Out Jack of
Cyclone for STMicro
Jumpers 2 and 3 are enabled. Jumpers 1, 4 and 5 are left open, as shown in
.
Содержание Cyclone for STMicro
