10
Cyclone for STMicro - User Manual
CYCLONE FOR STMICRO
P&E only recommends switching DC voltages up to 24 Volts.
3.6
Power Connectors
The Cyclone for STMicro provides a Target Power Supply Input Jack and a
Target Power Supply Output Jack with 2.5/5.5 mm Pin Diameter. The power
jacks are connected or disconnected by two electromechanical relays. When
connected, the Center Pin of the Target Power Supply Input Jack is
connected to the Center Pin of the Target Power Supply Output Jack. When
disconnected, both terminals of the Target Power Supply Output Jack are
connected to GND via a 1W, 100 Ohm resistor.
Figure 3-6: Power Connector Locations
3.7
Jumper Settings
The jumpers must be set differently for various power management options
that the Cyclone for STMicro offers. If the Cyclone for STMicro is not being
used to manage the target’s power, only Jumper 5 needs to be installed.
Please see
Section 3.15 - Target Power Management
for the correct jumper
settings for other power management options.
3.8
Debug Connector Mechanical Drawing
The Cyclone for STMicro provides a standard single-row, 4-position ERNI
214012 header for STM8 SWIM communication protocol, and 10-position, 14-
position, and 20-position 0.100-inch pitch dual row 0.025-inch square headers
for other STMicro targets. The mechanical drawing for dual row headers is
shown below.
Содержание Cyclone for STMicro
