PB Heat Peerless Partner PV-120, Руководство по эксплуатации и установке

Страница: 13 / 31

12
A. WATER TEMPERATURE CONTROLS

A periodic inspection of the operating controls, heat
exchanger and wiring should be made by qualified service
personnel.
 Temperature of the water should be tested periodically at the
faucet to be sure thermostat is working properly.
B. TEMPERATURE CONTROL
 The water heater is delivered with an ETC101 thermostat. A
factory set temperature setting of 120

F and differential
setting of 10

F. Any temperature adjustment of the
thermostat must be made by qualified service personnel, as
shown below.
WARNING: See WATER TEMPERATURE REGULATION,
regarding safe water temperature before proceeding. Hot
water can cause scalding injuries.

Shut off or disconnect all electrical supply to heater.

Remove cover to Thermostat.
 Adjust right side lever to the desired temperature. Moving
lever down will decrease temperature.
(See THERMOSTAT
DIAGRAM 1). NOTE: Markings on slide are approximate.
Check temperature at faucet to ensure safe operating
temperature.

Adjust left side lever to the desired differential. The
thermostat will call for heat when the tank temperature has
fallen to the set differential degrees below the Temperature
set point.
 Reattach cover.

Reconnect electrical supply.
 Check faucet temperature to verify desired temperature is
achieved.
In order to set the temperature above 140

F ( NOT
RECOMMENDED ) you must remove the SCALD DANGER label
attached to the temperature slide.
CAUTION: Do not increase temperature above 140° without a
properly installed mixing valve in the system
– See
WATER TEMPERATURE REGULATION and SCALD
WARNING.