PB Heat Peerless Partner PV-120, Руководство по эксплуатации и установке

Страница: 5 / 31

4
INSTALLATION GUIDELINES
A. INSPECTING AND PREPARING THE HEATER
 Remove the cardboard box, which comes packaged with the
heater. It should contain the following: Thermostat, T&P
valve, brass
“T”, insulation, lid and screws.

Do not cover or damage the temperature and pressure relief
valve opening located in the topside of the tank (See
FIGURE 1 and FIGURE 2).
B. LOCATION

CAUTION: All tanks will eventually leak at some
unpredictable time.
 Do not place the heater where there is a risk of property
damage in the event of a leak.
 Place the heater on a solid foundation in a clean, dry location
nearest the boiler.

The heater should be protected from freezing and water lines
should be insulated to reduce energy and water waste.
 Leave sufficient headroom to service the heat exchanger and
electrical controls.
 Do not install in an area where flammable liquids or
combustible vapors are present.

CAUTION: The heater’s outer jacket is plastic and can
melt.

Do not install in close proximity to wood burning stove or
other high temperature apparatus.
NOTE: If heater is placed on blocks to raise it from the floor, be
sure to support the entire bottom with at least ¾" plywood on the
top of the blocks.