PB Heat Peerless Partner PV-120, Руководство по эксплуатации и установке

Страница: 6 / 31

5
C. PROTECTION FROM WATER DAMAGE
 CAUTION: All water heaters have a risk of leakage at
some unpredictable time.

IT IS THE CUSTOMER’S RESPONSIBILITY TO PROVIDE
A CATCH PAN OR OTHER ADEQUATE MEANS, SO THAT
THE RESULTANT FLOW OF WATER WILL NOT DAMAGE
FURNISHINGS OR PROPERTY.
The Warranty provided assures replacement within its terms, but
specifically does not warrant against consequential damage
caused by a leaking water heater.
D. TEMPERATURE AND PRESSURE RELIEF VALVE

WARNING: A POTENTIAL HAZARD TO LIFE AND
PROPERTY MAY EXIST IN ANY WATER HEATER IF AN
APPROVED TEMPERATURE-AND-PRESSURE RELIEF
VALVE IS NOT PROPERLY INSTALLED.

For protection against excessive pressures and temperatures
in this water heater, install temperature-and-pressure
protective equipment by local codes, but not less than a
combination temperature-and-pressure relief valve certified
by a nationally recognized testing laboratory that maintains
periodic inspection of production of listed equipment of
materials, as meeting the requirements for Relief Valves and
Automatic Gas Shutoff for Hot Water Supply Systems, ANSI
Z21.22-1971. This valve must be marked with maximum set
pressure not to exceed the marked maximum allowable
working pressure of the water heater (150psi). Install the
valve into an opening provided and marked for this purpose
in the water heater, and orient it or provide the tubing so that
any discharge from the valve will exit only within 6 inches
above, or at any distance below the structural floor and
cannot contact any live electrical parts. The discharge
opening must not be blocked or reduced in size under any
circumstances.

CAUTION: A relief valve is designed to discharge
excessively hot water. THE CUSTOMER IS
RESPONSIBLE TO PROTECT PROPERTY AND
PERSONNEL FROM HARM WHEN THE VALVE
FUNCTIONS.
 Install the T&P provided on hot water outlet of tank as shown
in FIGURE 1 and FIGURE 2.
 Care must be taken to be sure that the stem of the pressure-
and-temperature relief valve is immersed in the water within
the top 6 inches of the tank.

The drain line from the relief valve must not be concealed or
blocked and must be protected from freezing.