PB Heat Peerless Partner PV-120, Руководство по эксплуатации и установке

Страница: 8 / 31

7
𝑀𝑎𝑥 𝐿𝑜𝑜𝑝 𝐿𝑒𝑛𝑔𝑡ℎ =
(
𝑇𝑎𝑛𝑘 𝐶𝑎𝑝𝑎𝑐𝑖𝑡𝑦
10
)
(𝜋 ∗ 𝑃𝑖𝑝𝑒 𝑅𝑎𝑑𝑖𝑢𝑠 ∗ 𝑃𝑖𝑝𝑒 𝑅𝑎𝑑𝑖𝑢𝑠)
NOTE: Be sure to connect Boiler Supply Line (from the boiler)
to the “HX in” fitting and Boiler Return Line (to the boiler) to
the “HX Out” fitting.
Construction of Single Wall Heat Exchanger

Consists of one copper tube, wound into a coil. The ends of
the tube are soldered into the brass fittings that mate with the
hot water supply.
Construction of Double Wall Heat Exchanger

Not Applicable.
G. FILLING THE HEATER
 Check that the temperature-and-pressure relief valve has
been properly installed
(mandatory requirement).
 Completely close the drain valve.

Open the highest hot water faucet to allow air to escape from
piping.

Open the valve to the cold-water inlet and allow the heater
and piping system to completely fill, as indicated by a steady
flow of water from the open faucet.
H. THERMOSTAT INSTALLATION

Place hole in back of Thermostat over the temperature
sensor leads. It should fit flush against the tank. Use the
provided self-tapping screw (Screw A) to attach case back
directly to the Peerless® Partner® PV Series. (See
THERMOSTAT DIAGRAM 1)
 Connect temperature sensor wires to press release
connector (if equipped). (See THERMOSTAT DIAGRAM 4)

Run all 24V
AC
wiring thru the square notch on bottom of
thermostat case. (See THERMOSTAT DIAGRAM 3 )

The Peerless® Partner® PV Series may operate as a
separate heating zone using either the heating system
circulator and an appropriate zone valve, or a separate
circulator dedicated for water heating. (See FIGURE 1 and
FIGURE 2).

In both systems, the Peerless® Partner® PV Series is
controlled through the thermostat on the heater. (See
FIGURE 1 and FIGURE 2).
 Be certain to replace thermostat cover using the black screw
provided.