Pavone Systems MC 315 Series, Техническое руководство

Страница: 24 / 62

Page 22
CONFIGURATION PARAMETERS
All the configurable parameters are described on the following pages. For the purpose of describing
each parameter, if applicable, the fieldbus address corresponding to such parameter is specified. If the
parameter is of the selectable type, the value to be entered into the register for the desired selection is
specified in “[ ]”.
WEIGHT CONSTANTS MENU
This menu can only be accessed in case of FREE operation or of METRIC operation with access of the
authorized staff via password.
CAPAC LOAD CELL CAPACITY [1103-1104]
Defines the value corresponding to the sum of the nominal capacity of the load cells expressed in kg.
In case of systems with one load cell and “N” fixed supports, enter the cell’s capacity value for the
total number of supports. This figure is the full-scale value of the weighing system. Following a change
of the parameter’s value, theoretical weight calibration is recalculated.
Values: 1 to 999999
Default: 0
SEnSIt LOAD CELL SENSITIVITY [1105]
Set the value corresponding to the average load cell sensitivity in mV/V. Values between 0.0 and 4
mV/V are accepted. If no value is set, 2mV/V is assumed.
Following a change of the sensitivity value, theoretical weight calibration is performed.
Values: 0.0000 to 4.0000 mV/V
Default: 2.0000
rESoL DIVISION VALUE [1101÷1102]
The value of an individual division in kg. The ratio of the system’s capacity to the division value repre-
sents system resolution (number of divisions).
Following a change of the division value, if the system’s capacity is not modified, weight calibration
is automatically adjusted.
Selectable values:
0.0001 - 0.0002 - 0.0005
0.001 - 0.002 - 0.005
0.01 - 0.02 - 0.05
0.1 - 0.2 - 0.5
1 -2 - 5
10 - 20 - 50
Default: 1
Note: Division value setting via Modbus occurs differently than via the unit. Please refer to addresses
1101 and 1102 in the Modbus register table.