Partlow MIC 6000, Инструкция по установке, монтажу и эксплуатации., Страница: 23 / 82

P
AGE
23
B. Upon power up, "6XXX" will be displayed (X representing digits), then "XXX-",
identifying the seven digit model number as defined in the order matrix. Next, the
software revision level will be displayed in the format "rX.XX". Then "tSt1", "tSt2", and
"tSt3" will be displayed while Test 1 thru 3 are executed automatically. Upon successful
completion of these tests, "Ctrl" (for the Control mode) or "oFF" (for the Off mode) will
be displayed for about three seconds. During this time the operator may select another
mode prior to the instrument automatically going into the Control mode.
C. If any error messages are displayed, refer to Section 5.4, page 56 for a definition of these
error messages and the required action.
D. If the instrument has been configured or operated previously, the mode that the
instrument will go into upon power up, depends on what mode the instrument was in on
power-down and how it has been programmed.
Front Panel Operation 3.4
3.4.1 DIGITAL DISPLAY AND STATUS LED's
The digital display provided has 4 digits and a decimal point. Each digit has seven segments
and is capable of producing numeric characters from 0-9 and certain alpha characters. The
digital display is used to provide indication of process variable as well as displaying codes
used for configuration and operation of the instrument. The display includes the following
Status Indicator LED's:
Label Color Function
MAN Amber Lights when the Manual StbY mode is on.
OUT1 Red Lights when Output 1 is on.
OUT2 Amber Lights when Output 2 is on.
ALRM Red Lights when either Alarm is on or active.
SEG 1 Red Lights to indicate the profile section segment number
thru that is active.
SEG 6
RAMP
Red Lights during the Ramp section of any profile segment.
SOAK Red Lights during the Soak section of any profile segment.
SP Green Indicates that the value displayed is the setpoint.
C Red Lights to indicate that the process value is in terms of
degrees C (Celcius)
F Red Lights to indicate that the process value is in terms of
degrees F (Farenheit)
U Red Lights to indicate that the process value is in terms of
engineering units.
- Red Lights to indicate a negative displayed value