Parkside PBLG 52 A1, Перевод оригинальной инструкции

Страница: 21 / 88

PBLG 52 A1 ■ 18
│ GB │ IE
Vibrations
WARNING!
► You can reduce the vibration risk, for example, the risk of Raynaud's
phenomenon (circulatory problems), by taking regular breaks during
which you rub your hands together.
■ Always wear protective gloves and ensure your hands are warm.
■ Take regular work breaks.
Before use
Setting up the appliance (see fig. A)
♦ Take the two hose clips + and slide them over the ends of the
flexible pipe .
♦ Push the larger end of the flexible pipe onto the curved pipe and
tighten the hose clip using the flat-head screwdriver $ .
♦ Slide the control pipe into the flexible pipe section and tighten
the hose clip using the flat-head screwdriver
$
.
♦ First loosen the fixing screws
/
on the operating lever .
♦ Slide the operating lever onto the guide of the head pipe .
♦ Attach the operating lever using the supplied fastening screws
/
and locking nuts .
♦ Push the pipe extension - onto the control pipe .
To fix the pipe extension
-
in place, turn it clockwise (see fig. A) and
secure it by tightening the inserted screw.
If an extension is required, push the second pipe extension
onto the
previously mounted pipe extension
-
.
To fix the pipe extension in place, turn it clockwise (see fig. A) and
secure it by tightening the inserted screw.
♦ Push the desired end pipe (round)
3
or end pipe (flat)
"
onto the
pipe extension
-
or and fix it in place by turning it clockwise
(see Fig. A) and secure it by tightening the inserted screw.
NOTE
► Higher air velocity = flat tailpipe
"
► Normal air velocity = circular tailpipe 3
Disassembly is carried out in the reverse order.
Mixing fuel
The engine must be operated with a mixture of petrol and motor oil.
WARNING!
► Avoid direct skin contact with fuel and do not inhale fuel vapours.
■ Always use a mixture of unleaded petrol (at least RON 95) and special
2-stroke engine oil (JASO FD/ISO-L-EGD). Mix up the fuel mix
according to thefuel mix table.
■ Pour the correct amount of petrol and 2-stroke oil into the openings
provided in the enclosed mixing container
#
(see “Fuel mix table”).
■ Tilt the mixing container # to the side so that the filled oil can flow into
the chamber with the petrol.
■ Then give the mixing tank # a good shake.
Fuel mix table
Mixing process: 40 parts petrol to 1 part oil
Petrol
2-stroke oil
0.5 litres 12.5 ml
Adding fuel
WARNING!
► Fill the fuel tank only when the engine is switched off and cooled
down. There is a risk of fire!
♦ Always clean the area around the fuel tank cap 1 before filling to
prevent dirt getting into the fuel tank % .
Use a dry, lint-free cloth to do this.
♦ Place the appliance on a suitable, level surface so that the fuel tank
cap
1 is facing upwards.
♦ Turn the fuel tank cap
1
anticlockwise and remove it.
The fuel tank cap
1
is connected to the fuel tank with an anti-loss
device and cannot fall down.
♦ Fill the fuel tank
%
with the fuel mix. Do not spill any fuel while filling
the fuel tank
%
and do not fill it to overflowing.
♦ Wipe up any spilled fuel immediately.
♦ Turn the fuel tank cap 1 clockwise to close it.