Parkside 354721 2010, Перевод оригинальной инструкции

Страница: 24 / 232

24
GB IE
Function Description
The electric hedge trimmer is driven by an
electronic motor. The equipment is double-
insulated for safety and does not require
earthing.
The hedge trimmer is equipped with a dou-
ble-sided safety cutter bar. When cutting,
the blades move backwards and forwards
in linear motion.
The unit can only be operated with the
safety switch depressed, in order to protect
the operator. In addition, the hand guard
protects against branches and briars.
Please note the following descriptions for
the function of the operating components.
Technical Data
Long-Handle
Hedge trimmer.....................PHSL 900 A3
Input voltage rating ... 230-240 V~, 50 Hz
Input power ................................900 W
Idle speed n
0
.........................1000 min -1
Cuts/min ...................................... 2000
Safety class ..................................... II
Degree of protection ....................... IPX0
Weight (incl. accessories) . approx. 5.9 kg
Cutting length ............................ 410 mm
Max. recommended
branch thickness ......................... 15 mm
Acoustic pressure level
(L
pA
) ................... 87.1 dB(A); K
pA
= 3 dB
Sound power level (L
WA
)
measured ......98.3 dB(A); K
WA
= 2.05 dB
guaranteed ........................ 100 dB(A)
Vibration (a
h
) at the
handle ........... 3.442 m/s 2 ; K= 1.5 m/s 2
round handle . 4.072 m/s 2 ; K= 1.5 m/s 2
Noise and vibration values have been de-
termined according to the standards and
regulations mentioned in the declaration of
conformity.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another. The stated
vibration emission value may also be used
for a preliminary exposure assessment.
Warning: The vibration emission value
may differ during actual use of the power
tool from the stated value depending on the
manner in which the power tool is used.
Try to keep the exposure to vibrations as low
as possible. Examples of measures to reduce
vibration exposure are the wearing of gloves
when using the tool and limiting the working
hours. All parts of the operating cycle have
to be considered while doing so (for exam-
ple, times when the power tool is switched
off and times when it is switched on but run-
ning without any load).
Notes on Safety
This section deals with the basic safety
regulations to be observed when working
with the electric hedge trimmer.
Symbols in the manual
Warning symbols with in-
formation on damage and
injury prevention.
Hazard symbol with infor-
mation on the prevention of
personal injury caused by
electric shock.
Instruction symbols with information
on preventing damage.
Always remove the mains plug be-
fore working on the appliance.