9
INSTALLATION, OPERATION, AND MAINTENANCE MANUAL ALIGN™ MULTI-GAS GENERATOR
3.4 Regulatory Certifications
The generator is certified to the electrical safety requirements as specified by the IEC, UL, and CSA
Standards by the certifying agency, the CSA Group. All three models carry the CSA and CE marking and
are certified to the CB Scheme.
This product meets EMC compliance. The internal receiver tank is CRN registered and ASTM certified.
4 INSTALLATION
4.1. Receiving the Generator
All installation, operation, and maintenance activities for the ALIGN Multi-Gas Generator should be
performed by trained personnel practicing appropriate health and safety practices to avoid personal
injury or damage.
The ALIGN Multi-Gas Generator is packed in a wooden shipping container. Upon receipt of the
product, carefully inspect the packaging for damage. If the packaging is damaged, inform the delivery
company immediately and contact Parker Hannifin Customer Service at 800-343-4048.
Remove the wire L-shaped fasteners from the indicated side of the container (see Figures 1&2).
DO NOT ATTEMPT TO LIFT THE GENERATOR FROM THE CONTAINER.
DO NOT MOVE THE GENERATOR BEFORE SECURING THE RAMP.
Fold down the side of the crate so it can be used as a ramp. Securing pins are located at the bottom
of the crate. Insert these pins into the holes at the top of the ramp. Remove the shelf and foam around
the generator. Remove the components and accessories from the shelf inside the crate.
Figure 1
Figure 2
Perform with 2 people:
Release the generator’s locked casters and carefully guide the generator
down the ramp. Move the generator and installation kit to its installation location.
(see Figures 3-6)
IOM_PKR_Align Multi-Gas Generator_022021.indd 9
IOM_PKR_Align Multi-Gas Generator_022021.indd 9
2/17/2021 1:11:45 PM
2/17/2021 1:11:45 PM
