Parker 650S Series, Руководство по эксплуатации продукта

Страница: 76 / 144

Programming Your Application
6-25
650S AC Drive
MMI Parameters Table
Display Parameter Description Range Default
SET::I2P Menu
I2T INHIBIT Inhibit/enable the action of the motor protection. 0=FALSE
1=TRUE FALSE
I2T LIMIT MOTOR This is diagnostic information:
0 : motor load level is lower than 100%
1 : motor load level is higher than 100%
0/1
I2T LIMIT LOAD This is a diagnostic information.
Indicates the percentage of motor load. This value is based on PERM
CURRENT (permanent motor current). The time variation is based on
THERMAL TIM CST
---%
I2T MOTOR TRIP State of the I2T trip, reported as MOTOR OVERTEMP:
0: the motor is running, the motor load level is lower than 100%
1: the motor is stopped; the motor load level is higher than 100%
0=FALSE
1=TRUE
SET::POL Menu
POLARISATION Set this parameter to enter the motor polarisation mode
Clear it for standard SV control mode 0=FALSE
1=TRUE
POLAR START Set this parameter to enable the motor polarisation mode
Clear it to disable the motor polarisation mode 0=FALSE
1=TRUE
MOTOR PHASE Select on which motor phases the motor polarisation is applied.
When the motor polarisation is enabled, changing the motor phase
allows to rotate the motor like a stepper motor.
That gives the possibility to verify the correct motor phase connection to
get a clockwise direction for a positive speed setpoint 0=U PHASE
1=V PHASE
2=W PHASE
CURRENT This diagnostic gives the current setpoint applied to the motor during the
motor polarisation mode. ---A
SET::POS Menu
START A False to True transition starts the move command. 0=FALSE
1=TRUE
ABORT When True the ongoing move is aborted (null speed set-point) and no
further move command can be started. 0=FALSE
1=TRUE
TARGET Specify the move command target. Depending of the move type it is an
absolute, a relative or a travel distance. -32768 to 32768 0