Parker 650S Series, Руководство по эксплуатации продукта

Страница: 61 / 144

6-10
Programming Your Application
650S AC Drive
MMI Parameters Table
Display Parameter Description Range Default
BAUD RATE
F
Selects the Baud Rate for the MODBUS protocol. 0 : 1200
1 : 2400
2 : 4800
3 : 7200
4 : 9600
5 : 14400
6 : 19200
7 : 38400
8 : 57600
4
PARITY
F
Selects the Parity for the MODBUS protocol. 0= NONE
1= ODD
2= EVEN
0
REPLY DELAY ms The time in milliseconds between the drive receiving the complete
request from the communications master (PLC/PC) and replying to this
request. 0 to 200 5
OP PORT
PROTOCOL
F
Selects the protocol to be used by the keypad port on the front of the
drive. When EIBISYNC ASCII is selected, BAUD RATE is 19200 and
PARITY is EVEN. FIELDBUS is reserved for future use.
0= AUTOMATIC
1= KEYPAD
2=EIBISYNC ASCII
3= MODBUS
4= FIELDBUS
0
P3 PORT PROTOCOL
F
Selects the protocol to be used by the RS232 programming port on the
drive's control board. When EIBISYNC ASCII is selected, BAUD RATE is
19200 and PARITY is EVEN. FIELDBUS is reserved for future use.
As S SE07 0
SET::SETP Menu
JOG ACCEL TIME As P 4, for Jog 0.0 to 3000.0s 1.0
JOG DECEL TIME As P 5, for Jog 0.0 to 3000.0s 1.0
RAMP TYPE Selects the ramp type 0=LINEAR
1=S 0
S RAMP JERK Rate of change of acceleration of the curve in units per second³ 0.01 to 100.00 s3 10.00
S RAMP
CONTINUOUS When TRUE and the S ramp is selected, forces a smooth transition if the
speed setpoint is changed when ramping. The curve is controlled by the
S RAMP JERK parameter. When FALSE, there is an immediate transition
from the old curve to the new curve
0=FALSE
1=TRUE 1
MIN SPEED MODE
Selects a mode to determine how the drive will follow a reference:
Proportional : minimum limit, Linear : between minimum and maximum. 0=PROP.W/MIN.
1=LINEAR (used by
the 601 product)
0
SKIP FREQUENCY 1 This parameter contains the centre frequency of skip band 1 in Hz 0.0 to 240.0 Hz 0.0