Paragon SYMPHONY CF, Руководство пользователя

Страница: 5 / 24

5 LT5245 (2:02/09)
Paragon Symphony CF Users Instructions
SECTION ONE Introduction Continued
• Care must be taken to prevent any damage being caused to surrounding soft furnishing or
decoration; e.g. many embossed vinyl wall coverings may become discoloured if placed too close
to the appliance. Combustible material i.e. wall panelling or wallpaper must be removed from
behind the fire and fire trim.
• It is advised that this appliance is serviced annually; as it is more likely to provide trouble-free
operation.
• In GB (Great Britain) the fire does not normally require purpose built ventilation, but if for any
special reason purpose built ventilation is provided it should be checked periodically to ensure
freedom from obstructions.
• In IE (Ireland) permanent ventilation must comply with the current edition of IS813.
SECTION TWO Operating the Appliance
Before attempting to operate the appliance check that nothing has been placed in front of the
appliance that may interfere with the remote sensor operation.
To light the appliance using the remote hand set:
a. Point the remote control hand set in the direction of the
appliance and simultaneously press the buttons marked
‘ ’ and ‘standby’. Continue to hold in these two buttons
until a ‘bleep’ is heard (approximately 2-3 sec.) and then
release these buttons. The appliance will automatically
go through the ignition sequence and the pilot should
ignite. Once the pilot is alight the appliance will
automatically go to the high setting (approximately 20-
25sec).
b. If the ignitor stops sparking and the pilot fails to light
press the
' '
button before repeating this procedure.
c. The appliance can be adjusted up or down by pressing the appropriate button
' '
(low setting) or
' '
(high setting). These buttons have a duel function. If they are pressed until a ‘bleep’ is heard
and then released immediately the appliance will automatically go to the maximum
' '
or
minimum settings
' '
. On the other hand if the button is not released gradual adjustment is made
until the button is released or until the maximum or minimum setting is reached.
d. To switch off the appliance press the
' '
button. If the appliance is to be switch off for a short
period it is recommended that the ‘standby’ button be used, this switches the main burner off but
leaves the pilot on and will extend battery life.
e. The appliance can be switch off with out using the hand set by removing the appliance batteries
located behind the ash pan cover. When the batteries are removed there will be a delay (up
3minutes) after which double bleeps may be heard and shortly after the appliance will extinguish.
Ensure that the battery is reconnect once the fire as been extinguished. The appliance cannot be
operated without the use of the handset.
NOTE: If the fire is extinguished for any reason wait 3 minutes before relighting.
LOW BATTERY INDICATION (HAND SET)
If while pressing any of the buttons on the remote hand set the low battery indicator lamp either stops
flashing or appreciably slows then the battery should be changed.