Paragon SYMPHONY CF, Руководство пользователя

Страница: 6 / 24

6 LT5245 (2:02/09)
Paragon Symphony CF Users Instructions
SECTION TWO Operating the Appliance Continued
TO REPLACE BATTERY IN HAND SET (9V
SIZE MN1604 OR 6F22)
Remove the cover from the rear of the handset and fit
replacement battery. Take care not to stain the battery
connections.
LOW BATTERY INDICATION (APPLIANCE)
If you hear a double ‘bleep’ sound come from the
appliance this indicates the appliance battery pack is low
and should be changed as soon as possible. The appliance will continue to work normally for a short
period but if the warning is ignored you may experience difficulty lighting the appliance or the
appliance may automatically switch off for no apparent reason.
NOTE: The appliance cannot be used when the battery is completely discharged.
TO REPLACE APPLIANCE BATTERIES (6 High Power Alkaline AA 1.5V)
(Rechargeable batteries can be used providing they are a nickel metal hydride type 1.5V AA
with a minimum capacity of 2200mAh).
(A long life lithium battery is available as an optional extra call the number shown on the last
page of these instructions for further information).
a. Lift off fret and ash pan.
b.
The battery power pack or holder is located at the left hand side of the burner; carefully slide the
battery holder forward and replace the six high power alkaline AA batteries as a complete set or
recharge as appropriate.
WARNING, batteries will overheat if fitted incorrectly, when fitting
the batteries ensure that they are fitted as per the marking on the rear of the holder (i.e.
minus of battery against spring).
If rechargeable batteries are used they MUST be a Nickel
Metal Hydride type with a minimum capacity of 2200mAh.
c. If the appliance is
fitted with the special
lithium
battery
(optional) disconnect
the wires at the
battery
connector
and replace ensuring
the connection is made correctly.
d. Important: Place the battery pack
or holder inside the insulation
blanket and ensure that it is placed
flat to the left hand side of the
appliance with the leads facing to
the left. Place battery lead into clip
as shown and refit fret and ash pan
cover.