Paradyne FrameSaver SLV 9124, Техническое описание

Страница: 228 / 346

Operation and Maintenance
10-16
9124-A2-GH30-00 June 1999 - Preliminary
Table 10-6. Health and Status Messages (4 of 6)
Message What To Do What It Indicates
LOS at Network 1 A Loss of Signal (LOS)
condition is detected on the
network interface. Clears
when the ratio of ones to
zeros received is greater
than or equal to 12.5%.
1. Network cable problem.
2. T1 facility problem.
1. Check that the network cable
is securely attached at both
ends.
2. Contact your network provider.
LOS at DSX-1 A Loss of Signal (LOS)
condition is detected on the
DSX-1 interface. Clears
when the ratio of ones to
zeros received is greater
than or equal to 12.5%.
1. DSX-1 cable problem.
2. No signal being
transmitted from the
DTE.
1. Check that the DSX-1 cable is
securely attached at both
ends.
2. Check the DTE status.
NAM Download Failed A download attempt was
interrupted and failed to
complete.
H
Retry downloading.
H
Contact service
representative.
NAM Fail appears on
the System Health and
Status screen. The FrameSaver unit
detects an internal
hardware failure. Record the 8-digit code from the
System Health and Status
screen, then contact your service
representative.
Network Com Link
Down The communication link for
the COM port is down, and
the COM port is configured
for Net Link. Check the router connected to
the COM port.
OOF at DSX-1 An Out of Frame (OOF)
condition is detected on the
DSX-1 interface.
1. Incompatible framing
format between the DTE
and the FrameSaver
unit.
2. DSX-1 cabling problem.
Cleared when a reframe occurs.
1. Check that the framing format
for the DSX-1 (DTE) interface
is correct.
2. Check that the DSX-1 cable is
securely attached at both
ends.