Paradyne FrameSaver SLV 9124, Техническое описание

Страница: 135 / 346

Configuration
8-13
9124-A2-GH30-00 June 1999 - Preliminary
4. Respond yes or no to the
Delete All DLCIs and PVC Connections?
prompt (see page 8-11).
— If Yes is selected, all discovered and manually configured DLCI records
and PVC connections are cleared, except for the management PVC
between a data port and router. This is so communication with the
system remains.
— If No is selected, no previously discovered or manually configured DLCIs
or PVC connections are removed and newly discovered DLCIs will be
configured according to the new discovery mode.
5. Go to the Configuration menu and change any node-specific configuration
options that may be needed.
The following table shows the automatic configuration that occurs within the
FrameSaver unit when a Frame Relay Discovery Mode is selected.
Automatic Configuration for Selected Frame Relay Discovery Mode (1 of 4)
If the mode selected is . . . Then setup configuration is . . .
Multiplexed Management:
H
1MPort
(For DLCI Record information:
see Table 8-9,
DLCI Records
Options .
H
DLCI Records :
– Network: DLCI Number is automatically created
from the LMI status response message. This
DLCI will contain multiple EDLCIs: one for
Port-1 and one for management.
Port-1: DLCI Number is automatically created
for the port from the multiplexed network DLCI.
Example:
Network DLCI 1001
→
Port-1 DLCI 1001
– Network: DLCI Type is set to Multiplexed.
– Network: CIR (bps) is automatically determined
from LMI status update message if switch
provides this information. Otherwise, the port
rate is configured.
Port-1: CIR (bps) is set to the network DLCI’s
CIR.
– Committed Burst Size Bc (Bits) is set to the
network DLCI’s CIR.
– Excess Burst Size Be (Bits) is set to the network
port rate minus the network DLCI’s CIR.
– DLCI Priority is set to High.
1
The port rate is calculated at the time of discovery as the number of DS0s allocated to
frame relay. It is automatically configured once for each DLCI. Should the number of
DS0s change, this value must be manually recalculated and changed via the
Configuration branch.