BA_PH_680-200_EN_11-22.docx
28
7
Installation
and Connection
7.1
Check Delivery Conditions
Check the consignment for completeness and possible transport damage. In case of transport damage, please
keep the packaging and inform the shipping company and the manufacturer immediately! Later complaints
cannot be accepted.
7.2
Transport to the Installation Site
Figure 10: Machine transport
•
The machine is delivered on a transport pallet and is
bolted to the bottom of the pallet.
•
The slide table is secured with a transport lock.
•
The centre of gravity of the machine is approximately in
the middle of the transport pallet.
•
If the machine is transported by forklift truck, the pallet
must be raised in the area of the centre of gravity.
•
Move between the feet with a lift truck, lift the machine
only a few centimetres and move it to the installation site.
For transport by forklift pick up the machine as shown above, fork length minimum 1.20 m.
Caution: Risk of damaging the front plate, longer fork length is advantageous!
With the cross slide attached, the centre of gravity shifts towards the cross slide!
Pay attention to the danger of tipping over when transporting by forklift truck!
Be aware of possible crushing hazards when placing the machine (from the pallet to the
floor) by means of a forklift truck or similar. Pay particular attention to your hands and
feet and wear safety shoes and protective gloves as a precaution.
Danger to life when using a forklift truck! Keep a sufficient distance from the forklift truck
and watch its speed. Vehicles with combustion engines also produce toxic exhaust gases.
Wear a breathing mask if necessary.
•
Move the container to the desired location (using a forklift truck, overhead crane, etc.).
•
Loosen the 4 bolts on the feet of the machine.
•
Lift the machine out of the container and move it to the desired location.
•
Remove the transport locks on the slide table.
•
The bare parts of the machine are greased to protect them from corrosion.
Carefully degrease these parts protected against rust with petroleum or benzine.
Fire hazard! Do not smoke and do not light an open fire.
Do not use nitro thinner for cleaning. Painted surfaces of the machine can be damaged.
•
A foundation is not required. The floor must have a load-bearing capacity corresponding to the weight of
the machine. The weight of the machine is approx. 1150 kg, depending on the equipment more.
