23
22
U S E R MA N UA L
PA N D O R A E L I T E V2
Settings
To change settings and parameters of the system, select the SETTINGS menu by short presses of the
button and briefly press the
or
.
Briefly press
or
, button to select a sub-menu.
To enter a sub-menu, briefly press
button.
decrease
Enter/confirmation button
parameter
is enabled
parameter
is disabled
save parameter
exit a manu/submenu
Navigation buttons
increase
up
down
PROCEED TO THE SETTINGS MENU
(press briefly)
or
PROCEED TO THE SETTINGS/PARAMETERS
(press briefly)
MENU NAVIGATION
(press briefly)
up
down
EXIT THE MENU
(press briefly)
F
F
HISTORY
AUTOSTART
HEATER
SENSORS
TRACKING
SIREN
HANDS FREE
CHANNELS
GPS RECEIVER
GSM MODEM
VALET MODE
SETTINGS
HISTORY
VIEW EVENT HISTORY
This menu allows viewing the event history stored in the remote control memory. The remote control
displays an event name and its time.
!
t
he
NumbeR
of
eveNts
Is
lImIted
by
the
memoRy
of
the
Remote
coNtRol
.
AUTOSTART
AUTOMATIC ENGINE START SETTINGS
This menu allows configuring the automatic engine start and stop settings. A synchronized real-
time clock in the remote control and the base unit and other autonomous system settings allow to
implement set of conditions of engine start and operation regardless of whether the remote control is
in the radio coverage zone or not.
•
ENABLE
- this submenu switches on/off all automatic engine starts.
•
TIMER
- this submenu allows starting an engine every day at the scheduled time.
•
START TEMP
- this submenu allows starting an engine automatically when the engine temperature
is low.
•
WORK TIME
- This submenu determines the maximum engine operation time for automatic and
remote starts.
•
PERIODICALLY
- this submenu allows starting engine periodically with a configured time interval.
•
STOP TEMP
- this submenu determines the engine stop temperature.
!
I
f
you
hAve
Not
sAved
NeW
settINGs
,
Remote
ANd
AutomAtIc
eNGINe
stARt
settINGs
WIll
RemAIN
the
sAme
As
befoRe
.
e
NGINe
stARt
vIA
tempeRAtuRe
Is
AvAIlAble
oNly
If
tempeRAtuRe
seNsoR
Is
coNNected
. A
utomAtIc
eNGINe
stARt
settINGs
doN
’
t
Affect
Remote
eNGINe
stARt
fuNctIoNs
.
HEATER
CONTROL OVER AN ENGINE PREHEATER
This menu allows switching on/off an engine pre-heater.
SENSORS
SETTINGS AND ADJUSTMENT OF THE SENSORS
This menu allows controlling and adjusting sensors (shock/motion/tilt) sensitivity. SHOCK and
additional EXTERNAL sensors have separate sensitivity zones. Alarm zone triggers when there are
considerable impact on a sensor. If the alarm zone is triggered, the system will indicate it with light and
sound alarm for 30 sec. Warning zone triggers when there are minor impact on a sensor (the sensitivity
of the warning zone should be higher than the alarm level sensitivity for correct operation). Warning
level is indicated by one light and three sound signals.
