33
32
User manual
Pandora DXL-1820L/1830L service-security system
- press validator button again 10 times in no less than 20 seconds after entering validator code.
Emergency switching off ‘Validator’ mode:
1. For emergency switching off this function call the system’s number and dial DTMF command
998*
and code from the card.
2. This mode can be disabled by entering personal code from the plastic card on level 15 of
programming menu (see Level 15 description on page 32).
Level 12 Setting and updating GPS/GLONASS receiver
To update the firmware of GPS/GLONASS receiver via the 2,4GHz wireless interface, run the
GPS Loader software and enter the programming level 12. After entering, update software of GPS/
GLONASS receiver.
Level 15 Emergency disabling of immobilizer
To deactivate the immobilizer/Antihijack function enter the programming level 15, the system will
confirm the entering with green flash of LED indicator. Input the first digit of the secret code using
VALET button (press the button a number of times, equal to the first digit; pauses between presses
should not exceed 1 second). The system will confirm input with red flash of LED indicator. Enter the
other three digits in the same manner. The correct input will be confirmed with 2 short sound signals
of the siren and with red flash of LED indicator. To activate immobilizer/Antihijack function, enter
level 15, LED will confirm input with red flash. Press VALET button once, siren will emit 1 short beep.
Level 17 Setting up keyless bypass of built-in immobilizer
This level enters programming mode to teach algorithmic keyless bypass of built-in immobilizer.
LED indicator will be lit green when on this level. If system installation was performed correctly on
successful engine start using a key, LED indicator will flash green and siren will emit a short signal. To
save and finish, press VALET button. Now the system should be able to simulate key for remote starts.
For more in-depth instructions, use AlarmStudio.
Additional devices
Expansion module RMD-8 (see diagram on page 22)
Expansion module RMD-8 is designed to be used in conjunction with Pandora DXL-1700L, DXL-
1820L/1830L, 3050L and Professional service-security systems. RMD-8 allows to significantly expand
the capabilities of a system, provides the ability to connect to the vehicle power circuits (up to 20A)
and adds 8 additional programmable outputs (OUT) and 4 analogue inputs.
RMD-8 is mainly needed to allow remote engine start function via analogue connection when it is
not possible to remotely start engine via CAN-bus.
Module provides control over basic parameters needed for correct and safe operation of the
engine: temperature and engine speed, glow plugs control, state of oil lamp/charge and handbrake/
neutral.
Name of parameter
Value
Current consumption
no more than 7mA
Supply voltage
9-15V
Operating temperature range
from -40
to +85
o
C
The maximum load current, dial-out
RMD OUT-1 (+)
1А
RMD OUT-2 (+)
1А
RMD OUT-3 (-)
200mА
RMD OUT-4 (-)
200mА
RMD OUT-5 (-)
200mА
RMD K1
20А
RMD K2
20А
RMD K3
20А
Permissible amplitude of tachometer signal
3-300V
Dimensions
45,5х44х17 mm
