29
28
User manual
Pandora DXL-1820L/1830L service-security system
Changing core settings using VALET button
Level 1 Recording remotes into the system’s memory
Enter the first level of programming. Insert batteries to RF tags and record tags to the system
memory (pair) one by one.
To pair the radio tag, press the control button on the tag and hold it until 6th LED flash (then
release). If the recording was successful, the base unit will emit 1 beep.
Record supplementary tags in the same manner. Number of sound signals corresponds to the
sequence of recording tags.
To finish the recording of the remote units into the system, VALET button should be pressed again,
the status LED will produce series of red and green flashes; then switch on and off the ignition to leave
the programming mode.
WARNING!
IF THE CONTROL OVER SIREN IS CARRIED OUT USING RHM ENGINE COMPART-
MENT MODULE, SIREN SOUND SIGNALS WILL NOT BE EMITTED DURING RADIO
TAGS RECORDING!
Level 2 Changing the factory preset service PIN-code
• Indicator LED is not lit. Press VALET button the number of times equal to the first digit of the
new security code. Each pressing of VALET button is followed by red flash of the indicator. The interval
between presses should not exceed 1 second.
• The input will be confirmed with red flash of indicator.
• Enter the other numbers in the same manner.
• The input of the fourth number will be confirmed by series of red and green LED indicator flashes.
• Enter all four numbers again.
• If you were able to correctly enter code twice, the indicator will produce series of red flashes and
a new PIN-code will be recorded, the system will return to the programming mode.
• In case of the incorrect code input the indicator will be lit red and the system will return to a
programming mode.
After the input is complete, the indicator fades, the system awaits a new programming level input.
Level 3 Recording the idle speed to the system’s memory
At this programming level the idle turns speed of the engine is recorded (into non-volatile
memory). Upon entering this level you need to switch the ignition on and start the engine (it should
be warmed-up and the idle speed should match a normal rate for the heated engine). Wait until the
stable idle speed is reached (it takes about 30 seconds). Then press VALET button once.
Successful recording will be confirmed with 1 sound siren signal and with 3 signals in case of
unsuccessful recording.
The ignition should be switched off after recording. While on this programming level, you can
start and stop the engine many times – it will only be exited on VALET button press.
Level 4 Resetting to factory settings
To reset to the factory settings, you need to enter programming level 4, then press and hold
VALET button for 5 seconds until siren sounds. Once VALET button is released, the status indicator will
confirm a successful reset to factory settings with a long red flash.
Level 5 Programming of engine compartment module
1. Enter programming mode on level 5.
2. Perform programming according to the instructions to the device.
Level 6, 7 Programming of radio relay 1 and 2
1. Select the desired level of the programming menu 6 or 7 for programming radio relays 1 or 2
respectively.
2. Connect the wire 1 of the radio relay to a grounded spot.
3. Apply power (+12V) on the contacts 3 and 4 of the radio relay. Siren will confirm radio relay
recording to the memory with 1 beep.
4. After a successful radio relay recording, contact 3 should be disconnected and insulated,
contact 4 should be connected to the wire where there is a constant 12V when the ignition is switched
on and it does not dissapear until the ignition is switched off.
Level 8 Recording GPS/GLONASS receiver
Enter this level and connect power to the GPS/GLONASS receiver. Siren of the base unit will
confirm successful recording with 1 beep.
