5. Confirm the display on the LCD display, then press the
CAM (SET)
key to delete the selected Camera Position
Number.
If a mistake was made in the above steps, press the
MON (ESC)
key to cancel the selection.
6. Repeat the above steps for other camera position num-
bers.
When satisfied with all positions, press the Function
(F4)
button to exit from the programming mode.
●
Camera Position Test Mode
1. Select the desired monitor.
Refer to the Monitor Selection.
2. Select the CAM-P
(D5)
Menu shown below on the LCD
display by pressing the appropriate Direction button.
3. Pressing the Function
(F3)
button will display the menu
shown below on the LCD display.
4. Press the Function
(F1)
button to toggle the test mode
on and off.
If On mode is selected, the picture at each of the
selected camera positions is displayed on the active
monitor at intervals of 3 seconds, proceeding from the
lowest camera position number to the highest.
124
5
5. Select the Camera Position Number by pressing the
Numeric keys.
After completing the above steps, press the
CAM
(SET)
key to execute the selection.
If a mistake was made in the above steps, press the
Escape
MON (ESC)
key to cancel the selection.
Note:
Up to 1 000 positions can be registered on this
menu.
If an attempt is made to register more than 1 000
positions, “Data Full” appears on the LCD display.
6. Repeat the above steps for other camera positions.
When satisfied with all positions, press the Function
(F4)
button to exit from the programming mode.
●
Delete Camera Position Number
1. Select the desired monitor.
Refer to the Monitor Selection.
2. Select the CAM-P
(D5)
Menu shown below on the LCD
display by pressing the appropriate Direction buttons.
3. Pressing the Function
(F2)
button will display the menu
shown below on the LCD display.
4. Enter the camera position number to be deleted by
pressing the Numeric keys, and then press the
CAM
(SET)
key. The picture at the selected camera position
appears on the active monitor, and the LCD display
reads as shown below.
C
Exit
F 1
F 2
F 3
F 4
CAM-P Menu
Set Clear Test Mode
F 1
F 2
F 3
F 4
D5
CAM-P
Exit
F 1
F 2
F 3
F 4
C 01 Pre64 CAM-P9999
Input OK?-->Set/Esc
F 1
F 2
F 3
F 4
CAM-P Menu
Set Clear Test Mode
F 1
F 2
F 3
F 4
D5
Test1 CAM-P----
■
Act Exit
F 1
F 2
F 3
F 4
Act
Act
Off:
On:
CAM-P
Exit
F 1
F 2
F 3
F 4
Содержание WVCU550C - SYSTEM CONTROLLER UNIT
