Panasonic WV-SFN110, Руководство по эксплуатации

Страница: 101 / 208

•
Default:
–
When "G.726" is selected : 32kbps
–
When "AAC-LC (HIGH QUALITY)" is selected : 128kbps
Note
•
When selecting a smaller value for “Bandwidth control(bit rate)” (
®
page 130) while putting a priority
on the JPEG image transmission, select “16kbps” for “Audio bit rate”.
•
[Audio bit rate] is unavailable when “G.711” or “AAC-LC” is selected for “Audio encoding format”.
[Mic input volume (Camera to PC)]
Select a volume level on the PC to hear audio transmitted from the camera.
•
Mic High: The volume level will become high.
•
Mic Middle: The volume level will become middle.
•
Mic Low: The volume level will become low.
•
Default: Mic Middle
Note
•
These settings are linked with the volume settings of “Audio recording” and “Audio detection”.
[AGC (audio)]
Automatically adjusts the audio reception to a suitable volume. The degree to which the volume is adjusted
can be selected from High/Middle/Low.
When "High" is selected, it is easier to hear quiet sounds, but sounds may be heard as noise. If you do not
want to hear noise, select "Middle" or "Low".
•
Default: High
Note
•
This setting is also applied to the volume for [Audio recording] and [Audio detection].
IMPORTANT
•
If the [AGC (audio)] setting is changed after configuring [Audio detection], the volume of the sound that
is detected with [Audio detection] may change. In this case, make sure to check the [Audio detection]
setting.
[Mic input interval (Camera to PC)]
Select an interval for audio reception from the following.
20ms/ 40ms/ 80ms/ 160ms
•
Default: 40ms
Note
•
When a shorter interval is selected, the delay time will be shorter. When a longer interval is selected,
audio interruption may be diminished even though the delay time will be longer. Select the interval
according to the network environment.
•
“Mic input interval (Camera to PC)” is unavailable when “AAC-LC” or "AAC-LC (HIGH QUALITY)" is
selected for “Audio encoding format”.
[Permission level of audio trans./recep.]
Select an access level for audio reception from the following.
1. Level 1 only/ 2. Level 2 or higher/ 3. All users
•
Default: 3. All users
Note
•
Refer to page 125 for further information about the access level.
Operating Instructions 101
11 Configure the settings relating to images and audio [Image/Audio]