15
Preparations
When installing the camera on a wall or a ceiling, there are two methods as specified below.
(
+
Next page)
• Using a two-gang junction box
• Using the mounting base WV-Q115
Refer to all work related to the installation of this product to qualified service personnel or system
installer.
• The mounting base WV-Q115 is optional for WV-CW504F, WV-CW504FK. Use the screws sup
-
plied with the camera mount bracket.
• The mounting base WV-Q115 is supplied with WV-CW504S, WV-CW504SK. Use the screws
supplied with this product.
Important:
• Prepare the mounting screw according to the material of the area where the camera attach
-
ment (accessory) is to be installed. In this case, wood screws and nails should not be used. For
mounting a camera on a concrete ceiling, use an anchor bolt (M4) or an AY plug bolt (M4) for
securing.
(Recommended tightening torque M4: 1.6 N·m {1.18 lbf·ft})
• When using the provided camera attachment, make sure that either of the arrow marks faces
upward.
• Required pull-out capacity of a single screw/bolt is 196 N {44.06 lbf} or more.
• If a ceiling board such as plaster board is too weak to support the total weight, the area shall
be sufficiently reinforced.
• When using an optional mounting bracket, refer to the operating instructions of the bracket in
use.
The mounting conditions of the camera mount bracket are described as follows:
Installation
place
Applicable mount
bracket
Recommended
screw
Number
of screw
Minimum pull-out
strength
(per 1 pc.)
Ceiling/wall
(Two-gang junction box)
M4 or equivalent
4 pcs.
196 N {44.06 lbf}
Ceiling/wall
WV-Q115
(approx. 350
g
{0.77 lbs})
M4 or equivalent
4 pcs.
196 N {44.06 lbf}
Ceiling
WV-Q169
(approx. 700
g
{1.55 lbs})
–
–
*
* Make sure that the installed mount bracket can support more than 5 times of the weight of the
camera.
