11
Mounting screws
• The screws and bolts must be tightened
with an appropriate tightening torque
according to the material and strength of
the installation area.
• Do not use an impact driver. Failure to
observe this may cause overtightening and
consequently damage to the screws.
• When a screw is tightened, make the
screw at a right angle to the surface. After
tightening the screws or bolts, perform
visual check to ensure tightening is enough
and there is no backlash.
Do not remove or loosen the screws.
Do not remove or even loosen the screws (7
pieces) on the rear of the camera.
Otherwise, water exposure may cause damage
or malfunction of camera, or camera dropping
may result in injury.
