Panasonic Workio DP-3510, Руководство по обслуживанию

Страница: 383 / 858

383
JAN 2006 Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
(11) To decrease the height of the Finisher, turn the
Adjusting Bolt counter-clockwise as illustrated;
turn the Adjusting Bolt as required. (Perform this
for both Front and Rear Casters.)
(12) To correct any slope, loosen the fixing Screw
(Black) on both Front and Rear Casters on the
delivery side of the Finisher.
(13) To decrease the gap between the Finisher and
the Host Machine, turn the Adjusting Bolt
clockwise. Turn the Adjusting Bolt as required.
(Perform this for both Front and Rear Casters.)
(14) To increase the gap between the Finisher and
the Host Machine, turn the Adjusting Bolt
counter-clockwise; turn the Adjusting Bolt as
required. (Perform this for both Front and Rear
Casters.)
(15) Connect the Finisher to the Host Machine, and
check to see that the difference in height and the
slope are within the indicated tolerances;
otherwise, make the adjustments once again.
(16) When done, disconnect the Finisher from the
Host Machine, and tighten the fixing Screws
(Black) on the Casters.
(17) To prevent loosening of the adjusting bolts during
relocation of the machine, turn the adjusting
bolts about 90º in the direction of the arrow; be
sure not to over-tighten them, as such can lead
to displacement.
(18) Plug the AC Power Cord into the wall outlet and
turn the Main Power Switch on the Back and the
Power Switch on the Left Side of the machine to
the ON position.
9. Adjusting the Position for Saddle Stitcher
After installing the Finisher, perform the Saddle
Stitcher Operation for each paper size. If paper is not
stitched in the middle, follow the procedure below.
(1) Adjust the Fold position with the User preset
mode.
(Refer to the Operating Instructions for copier.)
(2) Perform the Saddle Stitcher Operation once
again for each paper size. Make sure that the
paper is stitched in the middle. If not, repeat the
procedures again.
Adjusting Bolt
Fixing Screws
(Black)
Adjusting Bolt
90