Panasonic Workio DP-3510, Руководство по обслуживанию

Страница: 147 / 858

147
JAN 2006 Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
6. If the gap is less than 5 mm, input a (+) value. If more than 5 mm, input a (-) value.
7. Press "STOP" key first and then press "FUNCTION" + "CLEAR" keys simultaneously to return to
standby.
3.9. QUANTUM Control in F8-14
To stabilize the initial print quality, the contents of the F8-14 function was changed beginning from June '02
production. (Starting with Serial No. FBG2Kxxxxxx)
1. Description of the Change
2. Field Installation Procedure
* For New machines, use the following procedures at installation.
* For Machines already set up, use the following procedures during PM
1. Make sure that the LAN cable is disconnected before performing F8-09
2. Make sure that paper is set in any paper tray before performing F8-09
3. After performing F8-14, please use the additional procedure manually for all machines
which were produced from Feb ’02 to May ’02 production.
(Serial No. range from BBG2Kxxxxxx to EBG2Kxxxxxx)
.
3. QUANTUM Control Timing
Refer to the following Table. .
Toner Density Sensor
Output Gain Adj.
Self-Adjusting
(QUANTUM) 1min
Ready
Go to Image
Quality Adj.
F8-14 Contents
Toner Density Sensor
Output Gain Adj.
Ready
Go to Image
Quality Adj.
F8-14 Contents
Current
New
Proceed to
F8-14
Turn Power
Switch OFF/ON
Ready
Wait approx.
90 sec.
Ready
Self-Adjusting
(QUANTUM) 1 min
Ready
Go to Image
Quality Adj.
Additional Procedure