Panasonic WJMX50 - MIXER, Руководство по эксплуатации, Страница: 18 / 42

OPERATION
A. Pre-operational setup
A-1. Power
1. Turn on the MAIN POWER Switch (131) located on the
rear panel The unit is now in stand-by mode. No
operations can be executed yet.
A-2. RESET Switch
1. ON position • • • Factory preset operation mode
It is recommended to normally keep the RESET Switch
(109) in the ON position. It would be helpful in case of
unexpected operational failure.
2. OFF position • • • Field Preset operation mode
The status of the operation mode will be remembered
when the power of the unit is turned off. And this
status, without Still, Strobe and Special function, is
later recalled when the power is restored
.
2. Press the OPERATE Button (1) on the operation panel
The unit is now in operation mode and the Cooling Fan
(130) located on the rear panel starts to rotate. The
LED's on the operation panel light up as shown if the
RESET Switch (109) was already in the ON position
.
A-3. DEMO Switch
1. ON position
The preprogrammed demonstration of the built-in
Effect functions of the WJ-MX50 will be automatically
displayed on an attached video monitor.
Note:
This feature is useful for demonstrating functions
to a new user to help familiarize him/herself with
the unit
.
2. OFF position
The unit reverts to standard operation mode. This
switch is normally set to the OFF position.
Notes:
1 If you do not use the unit for an extended period
of time or to shut off the power completely, switch
off the MAIN POWER Switch (131).
2. If the Cooling Fan (130) does not rotate, turn off
and disconnect the AC power cord. Call service
personnel before attempting further use.
3. The power of WJ-MX50 can be turned on from
the Stand-by mode by turning on the power of
AG-A800. In this case the LED of the Mix Select
Button (73) turns on instead of the Wipe Select
Button (74).
A-4. Confirm that the unit is in the operation mode. Then
set up the operation panel as mentioned in the next
operating procedure.
- 17 -