Panasonic WH-SHF09F3E5, Руководство по обслуживанию

Страница: 41 / 142

41
11.4 Outdoor Unit
11.4.1 Install the Outdoor Unit

After selecting the best location, start installation
according to Indoor/Outdoor Unit Installation
Diagram.
1 Fix the unit on concrete or rigid frame firmly
and horizontally by bolt nut (ø10 mm).
2 When installing at roof, please consider strong
wind and earthquake. Please fasten the
installation stand firmly with bolt or nails.
(Unit in mm)
140
355
44
620 140
20
2
5
450
(A
nc
hor
pit
ch)
(Anchor pitch)
11.4.2 CONNECTING THE PIPING
Piping size (Torque)
Model
Gas Liquid
WH-SHF09F3E5
WH-UH09FE5
WH-SHF12F6E5
WH-UH12FE5
ø15.88 mm
(5/8")
[65 N•m]
ø9.52 mm
(3/8")
[42 N•m]
Connecting The Piping To Outdoor Unit
Decide piping length and then cut by using pipe cutter.
Remove burrs from cut edge. Make flare after
inserting the flare nut (locate at valve) onto the copper
pipe.
Align center of piping to valves and then tighten with
torque wrench to the specified torque as stated in the
table.
Local pipes can project in any of four directions.

Make holes in the pipe panels for the pipes to
pass through.

Be sure to install the pipe panels to prevent rain
from getting inside the outdoor unit.
[Removing the service panel].
1 Remove the three mounting screws.
2 Slide the service panel downward to release
the pawls.
After this, pull the service panel toward you to remove
it.
CAUTION
Do not over tighten, over tightening cause gas leakage.
Front pipe panel
Rear pipe
panel
Mounting
screws
Service panel
Rear direction
Side panel
Downward
direction
Forward
direction
Close the tube joining area
with putty heat insulator
(local supply) without any
gap as shown in right fi gure.
(To prevent insects or small
animal entering.)
Be sure to use two spanners
to tighten.
(If the nuts are over
tightened, it may cause
the fl ares to break
or leak.)
Do not attach
the spanners
here
Putty or Heat
insulator
(local supply)