Panasonic WH-MDF12C6E5, Руководство по обслуживанию

Страница: 38 / 121

38
11.4.3 Wired Remote Controller Instalation
Attached Accessories
No. Name Qty. Diagram Remark
(1) Remote control 1
(2) Remote control cable 1 Length (15 m)
(3)
Screw
(M4 machine pitched - 30mm)
3
Installing the remote control to an outlet box
(embedded cable)
(4)
Screw
(M4 self tapping - 14mm)
3
Installing the remote control to the wall
(exposed cable)
11.4.3.1 Selecting The Installation Location
Allow sufficient space around the remote control
(1) as shown in the illustration above.
Install in a place which is away from direct sunlight
and high humidity.
Install in a flat surface to avoid warping of the
remote control. If installed to a wall with an
uneven surface, damage to the LCD case or
operation problems may result.
Install in a place where the LCD can be easily
seen for operation. (Standard height from the floor
is 1.2 to 1.5 meters.)
Avoid installing the remote control cable near
refrigerant pipes or drain pipes, else it will cause
electrical shock or fire.
11.4.3.2 Installing The Remote Control
Unit To The Wall
1 Remove the remote control (1) lower case.
(Insert a flat-tipped screw driver or similar tool
2 to 3 mm into one of the gaps at the bottom
of the case, and twist to open. Refer to the
illustration at right.)
Be careful not to damage the lower case.
2 Do not remove the protective tape which is
affixed to the upper case circuit board when
removing the remote control lower case.
3 Secure the lower case to an outlet box or wall.
Refer to (A) or (B) instructions below
depending on your choice of cable installation.
4 Be sure to use only the screws provided.
5 Do not over tighten the screws, as it may
result in damage to the lower case.
A. If Remote Control Cable Is Embedded
1 Embed an outlet box (JIS C 8336) into the
wall. Outlet box may be purchased separately.
Medium-sized square outlet box (obtain locally)
Part No. DS3744 (Panasonic Co., Ltd.) or
equivalent.
2 Secure the remote control lower case to the
outlet box with the two accessory screws (3).
Make sure that the lower case is flat against
the wall at this time, with no bending.
3 Pass the remote control cable (2) into the box.
4 Route the remote control cable (2) inside the
lower case through rear feeding-out direction.