Panasonic TH-50BF1E, Руководство по эксплуатации, Страница: 91 / 112

89
Options Adjustments
Item Adjustments
Maximum VOL level
Press button to adjust the maximum volume.
Off On
Off: The sound volume level can be set up to 63(maximum).
On: The sound volume level will not exceed the set point.
Notes:
• If the “Maximum VOL level” is set lower than the “Initial VOL level”, the “Initial VOL level” automatically
becomes the same as the “Maximum VOL level”.
• The volume display can go up to 63 regardless of the settings.
• You can hear the changed volume regardless of your volume setting before opening the options menu
if you adjust the volume when “Maximum VOL level” is “On” and cursor is on the menu.
Input lock
Locks the input switch operation.
Off HDMI1 HDMI2 SLOT INPUT
*
1 VIDEO COMPONENT
*
2 PC DVI-D
DIGITAL LINK MIRRORING Panasonic APPLICATION MEMORY VIEWER WHITEBOARD
*
1 “SLOT INPUT” is displayed when an optional Terminal Board is installed.
When a Terminal Board with dual input terminals is installed, “SLOT INPUT A” and “SLOT INPUT B”
are displayed.
*
2 “COMPONENT” may be displayed as “RGB” depending on the setting of “Component/RGB-in
select”. (see page 84)
Notes:
• Input switch can be used when this is set to “Off”. Two screen display cannot be selected.
• In two screen display mode, if anything other than “Off” is set, the value will be fixed as the value input
in the single screen display mode.
Button lock
Off MENU&ENTER On
Off: All the buttons on main unit can be used.
MENU&ENTER: Locks
MENU
and buttons on main unit.
On: Locks all the button on main unit except the Power switch.
Sets Button lock with the unit buttons in the following procedure.
Off: Press
+
/
four times→Press
INPUT
four times→Press
-
/
four times→Press
MENU&ENTER: Press four times→Press
+
/
four times→Press
INPUT
four times→Press
On: Press
-
/
four times→Press four times→Press
+
/
four times→Press
Note: About how to reset the settings to defaults: “Normalisation” (see page 91)
Controller user level
Off User1 User2 User3
Off: You can use all of the buttons on the remote control.
User1: You can only use , , , , buttons on the remote control.
User2: You can only use button on the remote control.
User3: Locks all the buttons on remote control.
Note: About how to reset the settings to defaults: “Normalisation” (see page 91)
Off-timer function
Enable:
Enables the “Off-timer function”.
Disable:
Disables the “Off-timer function”.
Note:
• When “Disable” is set, the Off-timer is cancelled.
Initial startup
Last memory Standby On
Sets the power mode of the unit for when the power recovers from failure or after plugging off and in
again.
Last memory: Power returns in as the same state as before the power interruption.
Standby: Power returns in standby mode. (Power Indicator : orange/purple)
On: Power returns in power On. (Power Indicator : blue)
Note: When using multiple displays, “Standby” is preferred to be set in order to reduce a power load.
Display ID
Sets panel ID number when panel is used in “Serial ID”.
Set value range: 0 - 100
(Standard value: 0)
Serial ID function
Sets the panel ID Control.
Off: Disables external control by the ID.
On: Enables the external control by the ID.