22
Connect a cable which matches
the audio output terminal on the computer.
COMPUTER
Stereo mini plug (M3)
Conversion adapter
(if necessary)
Mini D-sub 15p
(Male)
(Female)
Shared with DVI-D IN.
RGB
PC cable
Audio
Connections
Notes:
•
With regard to the typical PC input signals that are described in the applicable input signals list (see page 102),
adjustment values such as for the standard picture positions and sizes have already been stored in this unit.
•
Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
•
The display resolution is a maximum of 1,440 × 1,080 dots when the aspect mode is set to “4:3”, and
1,920 × 1,080 dots when the aspect mode is set to “16:9”. If the display resolution exceeds these maximums, it
may not be possible to show fine detail with sufficient clarity.
•
Additional computer, cables and conversion adapter shown are not supplied with this set.
•
The PC input terminals are DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you
will need to make setting changes to the computer at the time of connection.
•
Some PC models cannot be connected to the set.
•
There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.
•
The computer shown in the illustration is for example purposes only.
•
Additional equipment and cables shown are not supplied with this set.
•
Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
•
Component Input is possible with the pin 1, 2, 3 of the Mini D-sub 15P Connector.
•
Change the “Component/RGB-in select” setting in the “Setup” menu to “Component”
(when Component signal connection) or “RGB” (when RGB signal connection). (see page 84)
Signal Names for Mini D-sub 15P Connector
Pin Layout for PC Input
Terminal
1
6
7
8
3
9
4
5
10
15 14 13 12 11
2
Pin No.
Signal Name
Pin No.
Signal Name
Pin No.
Signal Name
1
R (P
R
/C
R
)
6
GND (Ground)
11
NC (not connected)
2
G (Y)
7
GND (Ground)
12
SDA
3
B (P
B
/C
B
)
8
GND (Ground)
13
HD/SYNC
4
NC (not connected)
9
+5 V DC
14
VD
5
GND (Ground)
10
GND (Ground)
15
SCL
PC Input Terminals connection