Panasonic SC-HTX5, Руководство по эксплуатации

Страница: 8 / 28

RQT9478
8
Installing and assembling the rack
Connection
Glass shelf assembly
1
Loosen the screws (included) for the glass
shelf and insert the protrusions of the glass
holders (included) to the holes inside the
rack.
• Insert to the left and right holes with the same height.
• The height of the shelf can be adjusted at 2 different levels.
• Change the positions of holes for the glass holder to adjust
the height of shelf.
• When you do not install the shelf, keep the glass holders in a
safe place.
2
Insert the glass shelf (included) from front
to between the glass holders.
• Insert the glass shelf with its label side up and at right.
• Make sure the glass shelf has been set between both glass
holders before inserting.
• Set the glass shelf so its nonslip sheets are hidden under the
glass holders.
3
Tighten the screws for the glass shelf from
the bottom.
• Tighten the screws for the glass shelf fi rmly and fi x it so it
does not move.
• You can tighten the screws easily when you slightly lift the
glass shelf.
Tighten from the bottom.
Label
Nonslip sheet
(dotted line part)
Glass shelf
Loosen
screws at
this height. Screws for glass shelf
Glass
holder
Protrusion
Inside the rack
About equipment stored on the shelf
unit (mm)
Setting position
Shelf board
position
Height of
compartment
Maximum depth for
storing equipment
Recommended width
of equipment
Width of compartment
Upper shelf
A
Upper 117
340 430 610
Lower 144
Lower shelf
B
Upper 147
Lower 114
• Do not put equipment weighing more than 12 k g on the upper shelf
A
and lower shelf
B
.
• Image interference may occur if you put recording equipment such as a DVD recorder on the upper shelf
A
. Put it on the lower
shelf
B
if this occurs.
• When you install equipment with a heat dissipation louvers on the back side, make sure the heat dissipation louvers are not
blocked by the wire dressing part at the back center of the rack.
(Upper view)
Front
Back
Note
Installing the television
(Please also refer to the television’s operating instructions.)
Recommended: 42 inches or less
Place the TV stand in the center of the top board of the rack.
• Do not put equipment weighing more than 80 k
g
on the top board.
• The TV stand may be sold separately.
• Lift the television when placing it on the rack. Dragging it may damage the top panel.
(For details, refer to the television’s operating instructions.)
• When you use a stand with a rotating function, keep distance so the TV does not hit the wall.
• This system is not magnetically shielded. Do not put a CRT-based television.
(Upper view of the setup)
Wall
Arrange the
stand so
the TV does
not hit the
wall when
rotated.
TV
Stand
Note
Installing and assembling the rack