7
RQT7621
INT
R
O
≥
Check the screws you tightened in procedures 1-
3
and 2 -
3
if the pipe and speaker are loose (
➡
page 6).
∫
Front and surround speaker height
(Assembled diagram)
≥
Using the same polyfoam as done in procedure 2 will assist you in safely and securely fastening the speaker cables.
∫
For rear side of speaker
∫
For rear side of base
3
Connect the speaker cables.
4
Adjust the speaker height.
≥
Twist off the vinyl ends of the speaker cables.
Push!
r
:Copper
s
:Silver
Rear side of speaker
2
With one hand on the base, and the other
holding the speaker, adjust the height of
the speaker up and down.
Stopper screw
Screw to stop mounting plate from moving or
sliding below this point.
Phillips-head screwdriver
3
Tighten the mounting plate screw
securely.
1
Loosen the attached mounting plate screw
until the attached speaker is slightly loose
and adjustable.
Be careful not to loosen the screw too much
or the speaker may detach and fall.
Speaker
1122.5 mm
Pipe
Base
You can adjust within this
range.
715.5 mm
Stopper screw
Do not remove.
For your reference
You can enjoy good acoustics by
adjusting the height of the front and
surround speakers to the height of
the television so the center position
of both are approximately the same.
5
Fasten the speaker cable.
Press the speaker
cable into the
groove.
If there is any excess speaker
cable, thread the speaker
cable from the opening near
the top of the pipe while lightly
pulling the speaker cable from
the bottom of the base.
1
Press the speaker cable and thread
between the hooks.
2
Fit the speaker cable into the base
cover groove as far as possible.
Cable
HT1500_EB.book 7 ページ ２００４年５月２８日 金曜日 午後１時４１分
