Panasonic S-200PE2E5, Технические данные и руководство по обслуживанию

Страница: 176 / 188

8 8
Control of 2WAY SYSTEM
2. Wireless Remote Controller
Matching up Addresses
Setting Remote Controller Addresses
1. If you press
and at the same time , “ ” will blink.
2. While holding down, every time you press , it cycles from ALL 1 2 3…
Set it to the receiver address switch of the indoor unit you wish to operate.
3. When you release , the address that was displayed is set.
When you do this, if it corresponds to the receiver’s address setting, the buzzer sounds.
6 ALL.
Address
Display on the
Remote Controller
CZ-RWSC3
Position of
the Receiver’s
Address Switch The position of the
receiver’s address
switch does not
matter.
For 1, 2 and 3, set the switch on the
left and for 4, 5 and 6, to the right.
• Please do not hold the [Emergency Operation] button of the indoor unit down while the indoor unit’s display lamps are
blinking one after another.
• Make sure to operate while the indoor unit is stopped.
• The address of indoor unit is set to "ALL" at the time of the shipment.
NOTE
Control of 2WAY SYSTEM
2. Wireless Remote Controller
Use [Emergency Operation] in the following situations when there is an urgent need.
When the remote controller’s batteries have failed.
When the remote controller is broken.
When the remote controller is lost.
CZ-RWSC3
Start : press [Emergency Operation] of the receiver.
If the indoor temperature is 24 °C or greater when the unit starts running, it will act as a cooler.
If the indoor temperature is less than 24 °C when the unit starts running, it will act as a heater.
Stop : press [Emergency Operation] of the receiver again.
8-11. Emergency Operation
Start/Stop
CZ-RWSC3
8-10
SM830252-00_欧州_Single_天埋.indb 10 16/08/29 13:04:37