Settings
ENGLISH
37
Menu operation (continued)
▌
NO SIGNAL SHUT-OFF
If no image signal is input for the time set using the
timer, the projector will automatically enter into standby
mode.
Change setting
Change
setting
Change
setting
Change setting
DISABLE NO SIGNAL SHUT-OFF
is disabled
15 – 60
MIN.
Timer can be set at a 5-minute intervals
▌
INITIAL START UP
You can set the starting method when the power plug is
connected to wall outlet.
Change setting
Change
setting
Change
setting
Change setting
LAST
MEMORY
Projector starts from the last image
before the power plug was disconnected
STANDBY
Projector starts in the standby mode
ON
Projector starts immediately
▌
INSTALLATION
When installing the projector, select the projection
method according to the projector’s position.
(
page 15)
Change setting
Change
setting
Change
setting
Change setting
▌
HIGH ALTITUDE MODE
If you use the projector at high elevation, the
HIGH
ALTITUDE MODE
setting need to be
ON
to set the fan
speed to high.
Change setting
Change
setting
Change
setting
Change setting
OFF
Use in normal environment
(below 1 400 m (4 593 ft) above sea
level)
ON
Use at high altitude
(at 1 400 m – 2 700 m (4 593 - 8 858 ft)
above sea level)
NOTE:
The loudness of fan noise depends on the
•
HIGH
ALTITUDE MODE
setting.
▌
STANDBY MODE
You can change the standby mode setting.
Change setting
Change
setting
Change
setting
Change setting
ECO
The standby power is reduced to 0.4 W
to save power
NORMAL
The power of the projector can be
turned
ON
and the audio output can be
set active by controlling the computer
connected via wired LAN in standby
mode
▌
LAMP POWER
You can adjust the power of the lamp to save electricity,
prolong the lamp life and reduce the noise.
Change setting
Change
setting
Change
setting
Change setting
NORMAL
When higher luminance is required
ECO
When lower luminance is sufficient
NOTE:
This function is disabled when no input signal is detected.
•
ECO
•
setting is recommended when higher luminance is not
required such as in a small room.
