Panasonic PT-SRQ35KC, Руководство по эксплуатации

Страница: 293 / 323

Chapter 7 Appendix
—
Technical information
EN G L ISH - 2 9 3
Command transmission method
Trans m it using the follo w ing co mm and for m ats.
r
Transmitted data
Header Data section
Termination
symbol
Command
example
Hash v alue
“ C onnecting ” (
x
page 2 9 2)
‘
0
’
0x30
‘
0
’
0x30
C ontrol co mm and
(A S C II string )
(C R )
0x0 d
Data length 32 bytes 1 byte 1 byte U nde fi ned length 1 byte
f
Ex a m ple : Trans m ission of po w er supply status acquisition co mm and ( hash v alue is calculated fro m the user
na m e and pass w ord of the ad m inistrator account, and acquired rando m nu m ber )
“dbdd 2 dabd 3 d 4 d6 8 c5dd9 70 ec 0 c 2 9fa6 400 QPW ” (C R )
r
Received data
Header Data section
Termination
symbol
Command
example
‘
0
’
0x30
‘
0
’
0x30
C ontrol co mm and
(A S C II string )
(C R )
0x0 d
Data length
1 byte 1 byte U nde fi ned length 1 byte
f
Ex a m ple : The projector is po w ered on
“ 00001” (C R )
r
Error response
String Details
Termination
symbol
Message
“ E RR 1” U nde fi ned control co mm and
(C R )
0x0 d
“ E RR 2” Out of para m eter range
“ E RR 3” Busy state or no-acceptable period
“ E RR 4” Ti m eout or no-acceptable period
“ E RR5 ” Wrong data length
“ E RR A” Pass w ord m is m atch
Data length 4 bytes — 1 byte
Note
f
The projector w ill auto m atically disconnect the connection w ith the net w ork right after sending the co mm and. This is the speci fi cation based
on the security v ie w point to pre v ent unauthorized operation of this product by a m alicious third party. To send co mm ands continuously,
e x ecute the net w ork connection request e v ery ti m e the co mm and is to be sent. For details, refer to “ C o mm unication fl o w bet w een ser v er
and client ” (
x
page 2 95 ) .
When connecting in non-protect mode
Connecting
Follo w ing is the connection m ethod w hen the [ NE TWORK] m enu → [ NE TWORK S ECU RITY] → [ C OMM AN D
PROT EC T] is set to [DIS A B LE ].
1) Obtain the IP address and port number (Initial set value = 1024) of the projector and request a
connection to the projector.
f
You can obtain both the IP address and the port nu m ber fro m the m enu screen of the projector.
IP address Obtain fro m the [ NE TWORK] m enu → [ NE TWORK ST A T U S].
Port number Obtain fro m the [ NE TWORK] m enu → [ NE TWORK C O N TRO L ] → [ C OMM AN D PORT].
2) Check the response from the projector.