Panasonic PT-FW530, Руководство по эксплуатации

Страница: 90 / 156

Chapter 4 Settings — [PROJECTOR SETUP] menu
90 - ENGLISH
[ECO]
Select this item to reduce power consumption during standby.
Note
f
If [STANDBY MODE] is set to [ECO], you cannot use network functions when the projector is standing by. Also, you cannot use some RS-
232C protocol commands.
f
When set to [ECO], it may take approx. 10 seconds longer before the projector starts projecting after the power is turned on, compared with
when [NORMAL] is set.
f
When set to [NORMAL], it may take approx. 1 minute to enable the network function after connecting the power cord.
f
The setting of [STANDBY MODE] cannot be returned to the factory default even if the [PROJECTOR SETUP] menu → [INITIALIZE ALL] is
executed. (
Æ
page 97)
[RS-232C]
Set the communication conditions of the <SERIAL IN> terminal.
Setting the communication condition of the <SERIAL IN> terminal
1) Press
as
to select [RS-232C].
2) Press the <ENTER> button.
f
The [RS-232C] screen is displayed.
3) Press
as
to select [INPUT SELECT].
4) Press
qw
to switch the item.
[PROJECTOR]
Use the <SERIAL IN> terminal of the projector to perform RS-232C communication.
[DIGITAL LINK]
Performs RS-232C communication via the DIGITAL LINK output supported device (Model No.:
ET-YFB100G, ET-YFB200G) and the <DIGITAL LINK/LAN> terminal.
5) Press
as
to select [BAUDRATE].
6) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[9600]
Select the proper speed.
[19200]
[38400]
7) Press
as
to select [PARITY].
8) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[NONE]
Select the parity condition. [EVEN]
[ODD]
Setting the control commands of an existing projector
When controlling the projector on a computer, set use of control commands on a previously purchased Panasonic
projector. This allows the control software for an existing Panasonic projector to be inherited and used.
1) Press
as
to select [RS-232C].
2) Press the <ENTER> button.
f
The
[RS-232C]
screen is displayed.
3) Press
as
to select [EMULATE].
4) Press the <ENTER> button.
f
The [EMULATE] screen is displayed.
5) Press
as
to select an item.