99
Available commands are listed below.
T
Set System Priority value of this Switching Hub in LACP.
Press "T." The command prompt changes to "Enter system priority for LACP >."
A
Configure new trunking settings.
Press "A." The command prompt changes to "Enter trunk group admin key>." Enter a group
number you wish to configure. The command prompt changes to "Enter port member for
group key #>." Enter a port number you wish to do trunking. When entering multiple port
numbers, delimit with comma (,) with no space (example: "1,2,3"), or hyphenate the contin
-
uous numbers (example: "8-12"). Then, the command prompt changes to "LACP Active,
LACP Passive or Manual trunk setting(A/P/M)>." Enter "A" to make operation mode Active,
or "P" to make it Passive, or "M" to make it Manual, respectively.
R
Remove trunking settings.
Press "R." The command prompt changes to "Enter trunk group admin key>." Enter a group
number you wish to delete. The command prompt changes to "Enter port member port for
group key #>." Enter a port number you wish to do rdelete. When entering multiple port
numbers, delimit with comma with no space, or hyphenate the continuous numbers.
M
Modify the operation mode of trunking
Press "M." The command prompt changes to "Enter trunk group admin key>." Enter a group
number you wish to modify. Then, the command prompt changes to "LACP Active, LACP
Passive or Manual trunk setting(A/P/M)>." Enter "A" to make operation mode Active, or "P"
to make it Passive, or "M" to make it Manual, respectively.
O
Set System Priority value of this Switching Hub by port in trunking.
Press "o" to open the "Set port Priority" screen. For method of detail setting, refer to the sec
-
tion (4.6.2.b).
G
Display a status of LACP group.
Press "G." The command prompt changes to "Enter trunk group number >." Enter a key of
group you wish to display. (Only the group of which mode is Active or Passive can be
entered.) Then, screen changes to "LACP Status." For details, refer to the section (4.6.2.b).
Q
Return to the parent menu.
Note:
In this Switching Hub, it is possible to set members of up to 18 ports to one
group, but it is up to 8 ports that execute trunking operation. Members after
the 9th port in that group get into backup mode. When a failure occurred in
link of 1-8 port, one of them becomes a member that constructs trunk on
behalf of that port. In this case, priority order to become a member is deter
-
mined by Port Priority that is set in next section (4.6.2.b), and, when Priority
value is the same to all, trunk is constructed by a member starting from the
smallest port number in order.
