Panasonic Panafax UF-9000, Руководство по обслуживанию

Страница: 53 / 188

53
UF-9000
JUN 2004
Ver. 2.0
DP-180/190
415 XMT
(Polling)
B Remote side attempted to receive
message from your machine in
polling communication. Inform the remote side that your
machine does not have the polling
transmission feature.
416 RCV D Receiver did not detect post
command, such as EOP, MPS,
EOM, etc. Transmitter is defective.
Line quality is poor. (RTC signal is
distorted due to line noise)
SC PCB or FXB PCB are defective.
417 RCV C Receiver returned RTN in
response to post message. Line quality is poor. (There are
excessive errors in received data)
SC PCB or FXB PCB are defective.
418 RCV C Receiver transmitted PIN in
response to PRI-Q from
transmitter. (Transmitting operator
requests voice contact) Line quality is poor. (There are
excessive errors in received data)
SC PCB or FXB PCB are defective.
420 RCV B T1 timer (35 sec.) elapsed without
detecting 300 bps signal. Incorrect incoming call type (voice).
(Non-facsimile communication)
Transmitter is defective.
SC PCB or FXB PCB are defective.
421 RCV B Busy Tone is detected after
sending NSF Signal. Remote station disconnected the line.
Wrong number is dialed.
422 XMT B Content of NSF (or DIS) or NSC
(or DTC) was invalid. There is an incompatibility.
427 G3
RCV
B DCN received to NSF/CSI/DIS
transmitted. The interface is incompatible.
434 XMT or RCV B CD (response from Modem) did
not turn OFF within 180 sec. after
receiver detected FLAG signal. Remote unit is defective.
SC PCB or FXB PCB are defective.
436 G3 RX C DCN received after transmitting
FTT. Transmitter is defective or incompatible.
Line quality is poor.
456 RCV B Received relay transfer request or
confidential document to distribute
to an end receiving station or all
confidential mailboxes are used.
457 RELAY XMT
CONF. XMT/
POLL
B Remote unit does not have
Relayed XMT or Confidential
Comm. capability.
459 RCV C Failed training in Phase C. Line quality is poor. (Training signal is
distorted due to line noise)
SC PCB or FXB PCB are defective.
490 RCV C Sum of error lines exceeded the
limit (Function Parameter No. 70)
of 64 lines. Line quality is poor.
SC PCB or FXB PCB are defective.
494 RCV C Interval between two EOLs was
more than 10 sec. when receiver
received message data. Transmitter is defective.
Line quality is poor. (EOL is damaged
due to line noise)
SC PCB or FXB PCB are defective.
495 XMT
RCV C During reception, CD turned OFF
or continued ON for long time.
During communication, lost loop -
current. Line is disconnected.
Transmitter is defective.
SC PCB or FXB PCB are defective.
Fax Information Codes
Code Mode Phase Description of Problem Cause