Panasonic Omnivision PV-M1378W, Руководство по обслуживанию

Страница: 25 / 130

2-2
TV
CRT C.B.A.
Anode Cap
P354
Deflection
Yoke
Connector
Main
C.B.A.
TV Main C.B.A.
Clampers
Degaussing
Coil Connector
P4592
(Model : A, B, C,
D, E, F, G, H, I, J)
P4605
(Model : K)
Stereo Amp
C.B.A.
(Model : K)
P4604
(Model : K)
Clamper
CRT Unit
2 VCR Unit
VCR Unit
Disassembly Procedure
1. Discharge the Anode to the CRT Ground. Then, remove the
Anode Cap.
2. Disconnect the Connector P354 from the CRT C.B.A.
3. Carefully pull out the CRT C.B.A. from the CRT Unit.
4. Disconnect the Deflection Yoke Connector and the
Degaussing Coil Connector from the TV Main C.B.A.
5. (Model : A, B, C, D, E, F, G, H, I, J)
Disconnect the Connector P4592 on the Main C.B.A. and
remove the leads from the clampers.
(Model : K)
Disconnect 2 Connectors P4604 and P4605 on the Stereo
Amp C.B.A. and remove the leads from the clampers.
Fig. D3-1
6. (Model: A, B, C, D, E ,F)
Slightly lift up the rear side of the VCR Unit to release 2 Tabs
(B).
(Model: G, H, I, J, K)
Slightly lift up the rear side of the VCR Unit to release 4 Tabs
(B) and (C).
7. Slide the VCR Unit out as far as it will go.
Then, lift up the VCR Unit to release 3 Guide Tabs (A) and
remove the VCR Unit all the way out from the TV cavity.
VCR Unit
VCR Unit
Holes (A)
Guide Tabs (A)
Bottom view of VCR Unit
Tabs (B)
Tabs (C)
Opener Lever
Cassette Door Tab
View "A"
Cassette Door-Lid
Cassette Door-Lid
VCR Unit
View "A"
Press
CAUTION
Fig. D3-2
Reassembly Notes
Installation of VCR Unit
CAUTION
1) When installing the VCR Unit, swing the Cassette Door-Lid
all the way open until the Cassette Door tab clears the
Opener Lever.
2) Make sure that all guide tabs are aligned properly. Then,
press the VCR unit in.
Fig. D3-3