8
Installation checklist
Anchor bolts – have you removed them, and attached the cover caps properly?
Location – is your washing machine on a flat, stable surface? Does it run without
vibrating?
Water-supply hose – is it free from leaks, and is the water supply normal?
Water-drain hose – is it free from leaks, and does it drain normally?
Four adjustable stands – are they bolted securely to the washing machine?
Four stand cushions – are they standing flat? There may be abnormal sounds while
dewatering if it is not set flat.
Power supply – is the household dedicated mains socket, fully rated at AC 220V to
240V independently?
Test run after installation
● Check for water leakage, abnormal noise and proper drainage.
● To test your washing machine, do not load laundry into the drum and follow the
instructions below.
Turn on the tap.
Close the door and start the washing
machine.
● While holding down the Intensive
and Easy Ironing buttons press the
power On button.
● While the display appears as below
(three seconds), press the Intensive
button.
● The remaining time is displayed
as below (three minutes) and the
washing machine starts.
The washing machine will stop in
about three minutes.
Is there any abnormal noise?
Make sure the washing machine is
level.
Is there any water leakage?
Make sure the hoses are properly
connected.
You may get the following errors:
●
(
)
Are the hoses properly connected?
Is the drain clogged?
●
(
)
Have you properly connected the
water-supply hose and turned on the
tap?
After recovering from an error, opening and
again closing the door will cause the test to
resume.
NA-168VX2_Eng.indb 38
2010-1-26 13:06:02
