9
Press
[START]
to start the call.
•
You can also start the call by pressing
[ENTER]
.
10
When you want to end the call, press
[END]
.
•
The Home screen is displayed.
Note
•
When using the KX-VC1300, you can have video conference calls with a maximum of 3 parties
simultaneously. When you are using the KX-VC1600, the maximum is 5 simultaneous parties, and if
you have the activation key card (KX-VCS304) for enhanced features, you can make multiple-party
video conference calls with a maximum of 9 parties.
•
If the IP address contains 1 or 2 digit numbers, enter these numbers as they are. Do not enter like [.
001].
Example: The IP address is [192.168.0.1].
–
Correct entry: [192.168.0.1]
–
Wrong entry: [192.168.000.001]
•
To initiate a video conference call by entering a SIP URI (SIP user name@SIP domain name), you
must set
"SIP Server"
to
"ON"
and specify
"SIP Server Address"
,
"SIP Username"
, and
"SIP
Domain Name"
. Also, specify
"Digest Authentication"
,
"Authentication ID"
, and
"Authentication
Password"
as necessary (Page 118). For details, contact your network administrator.
•
When making a video conference call within your own SIP domain, you can make the call by entering
the other party’s SIP user name. When the other party is not within your SIP domain, you must also
include their SIP domain name in addition to their SIP user name.
When a SIP domain name is not specified, your own SIP domain name is automatically appended to
the address and the call is made. Be careful as this may result in calling the wrong party.
•
See Page 42 for details about the characters that can be input for address entry.
Enter a standards-compliant value. For details, contact your network administrator.
•
To initiate a video conference call by entering an MCU’s conference room number@IP address,
"SIP
Server"
and
"Gatekeeper"
must be set to
"OFF"
•
If the other party is using the KX-VC300/KX-VC600 with a software version older than 3.00 (not
including 3.00), you cannot make a video conference call using H.323. You must set
"SIP"
to
"ON"
on the call type settings screen (Page 118).
•
Items that have been set to
"OFF"
on the call type settings screen (Page 118) cannot be set in the
connection mode settings.
•
You can refer to the contact list or call history when entering a destination by following the procedure
below from the manual dial screen (you cannot enter a destination using the profile):
When using IP mode: the IP address (or host name), SIP URI (or SIP user name), H.323 extension,
H.323 name, or MCU’s conference room number@IP address
When using NAT Traversal mode: the connection number
1.
Press
[G]
.
•
A dialogue box to select either the contact list or call history is displayed.
2.
Use
[
][
]
to select the contact list or call history, and then press
[ENTER]
.
3.
Use
[
][
]
to select the contact you want to refer to.
•
For the contact list, you can use
[
][
]
or the numeric buttons of the remote control to select
•
For the call history, press
[G]
to switch between the incoming call history and the outgoing call
history.
4.
Press
[ENTER]
.
•
When using H.323, you can also call by entering the other party’s IP address (or host name) %H.323
extension (or H.323 name).
52
User Manual
Document Version 2015-03
Starting a Video Conference