Panasonic KX-NS500, Руководство по установке

Страница: 272 / 338

Up to 2 IP addresses can be assigned to the KX-NS500’s optional DSP cards. The following example shows the port number ranges
set for each IP address:
Installing KX-NT500 series IP-PTs at a remote site with Built-in Media Relay
Gateway
You can install KX-NT500 series IP-PTs at the remote site directly or from the local site as follows.
1.
Register the IP-PT. For details, refer to "5.8.1 Registering IP Telephones".
2.
Programme the settings for the IP-PT.
a.
Click Setup
®
PBX Configuration
®
Configuration
®
Slot .
b.
Click Virtual
®
V-IPEXT32 .
c.
Move the mouse pointer over the V-IPEXT32 card (Virtual IP Extension Card).
A menu will be shown under the mouse pointer.
d.
Click Port Property .
e.
Click the Remote Place tab.
f.
Configure the items shown below.
•
Change the value to Remote (MRG) for Phone Location .
g.
Click OK .
3.
Unplug the AC adaptor of the IP-PT, and then plug it in again to reboot the IP-PT manually. The IP-PT will
download settings automatically.
Installing IP-CSs (KX-NS0154 only) at a remote site with Built-in Media Relay
Gateway
You can install IP-CSs (KX-NS0154 only) at the remote site directly or from the local site as follows.
1.
Register the IP-CS. For details, refer to corresponding manuals of KX-NS0154.
2.
Programme the settings for the IP-CS.
a.
Click Setup
®
PBX Configuration
®
Configuration
®
Slot .
b.
Click Virtual
®
V-IPCS4 .
c.
Move the mouse pointer over the V-IPCS4 card (Virtual 4 IP Cell Station Interface Card).
A menu will be shown under the mouse pointer.
d.
Click Port Property .
e.
Click the Remote Place tab.
f.
Configure the items shown below.
•
Change the value to Remote (MRG) for Phone Location .
g.
Click OK .
3.
Unplug the AC adaptor of the IP-CS, and then plug it in again to reboot the IP-CS manually. The IP-CS
will download settings automatically.
Installing KX-UT series SIP phones at a remote site with Built-in Media Relay
Gateway
There are 2 methods to install KX-UT series SIP phones at a remote site:
•
Set up the phones at the main site using the KX-NS500, and then send them to the remote site.
•
Set up the phones without connecting them to the KX-NS500 at the main site, and then send them to the
remote site.
Setting up KX-UT series SIP phones at the main site, and then sending them to remote site
1.
Register the phone. For details, refer to "5.8.1 Registering IP Telephones".
2.
Programme the settings for the phone.
a.
Click Setup
®
PBX Configuration
®
Configuration
®
Slot .
272 Installation Manual
5.8.4 Installing IP Phones at a Remote Site with a Built-in Media Relay Gateway